用户手册
RIGOL
User’s Guide
© 2016 RIGOL TECHNOLOGIES, INC. All Rights Reserved.
PVP2150 无源探头
PVP2150 Passive Probe
电气规格
[1]
机械特性
Cable Length
120 ± 2 cm
环境指标
Operating: 2,000 m
80% relative humidity for temperature up to +31℃,
Pollution D egree
Pollution Degree 2
调节探头补偿 To Adjust the Probe Compensation
频率补偿 Frequency Compensation
使用探头进行测试前，首先检查探
头的频率补偿，将其调至与所使用
的示波器匹配。一般示波器的前面
板上都有一个校准信号输出端，将
探头连接至此信号输出端（探头衰
减设为 10X），令示波器显示测试方
波信号。将补偿调节棒插入探头前
端的补偿调节孔并顺时针/逆时针
转动调节棒直至示波器显示正确补
偿的方波（方波上方平整）。
Before taking any measurement using a probe, first check the
frequency compensation of the p rob e and ad just it to match the
oscilloscope used. Generally, the oscilloscope provides a
calibration signal output terminal at the front panel. Connect the
probe (set the probe attenuation to 10X) to the signal output
terminal to display a square waveform on the oscilloscope.
Insert the adjustme nt tool into the compensation adjustment
hole at the probe head and rotate it clockwise/counterclockwise
until the properly compensated square waveform is displayed
(flat-top square waveform).
补偿调节孔
Compensation Adjustment Hole
欠补偿
Undercompensated
探头指标 Probe Specifications
Electrical Specifications
带宽
Bandwidth
上升时间
[1]
Rise Time
衰减比
Attenuation Ratio
补偿范围 Compensation Range 10 pF to 25 pF
重量（仅探头） Weig ht (probe only) About 40 g
探头尺寸
探头顶端直径 Probe Tip Diameter 4.6 mm
温度 Temperature
海拨高度 Altitude
最大相对湿度 Max. Relative Humidity
污染等级
[1]
注
：连接至合适的 RIGOL 示波器。
[1]
Note
: Connected to an appropriate RIG OL oscilloscope.
1X: DC to 35 MHz
10X: DC to 150 MHz
1X: 10 ns
10X: 2.3 ns
10:1 or 1:1
Switchable
Mechanical Characteristics
Environmental Specifications
输入电阻
Input Resistance
输入电容
Input Capacitance
最大额定输入电压
Max. Rated Input Voltage
Operating: 0℃ to +50℃
Nonoperating: -20℃ to +70℃
Nonoperating: 15,000 m
decreasing linearly to 40% relative humidity at +50℃
Overcompensated
过补偿
正确补偿
Properly Compensated
1X: 1 MΩ ± 1% @ DC
10X: 10 MΩ ± 1% @ DC
1X: 50 pF ± 20 pF
10X: 10 pF ± 5 pF
1X: 150 V
10X: 300 V
RMS
RMS
CAT II
CAT II
电压降额
输入阻抗
联系我们
Voltage Derating
Input Impedance
CAT II IEC测量类别 II 是指在直接连
注：产品规格如有变更，恕不另行通知。
Note: Contents of this document are subject to change without notice.
接到低压设备的电路上进行
测量。例如，对家用电器、便
携式工具和类似的设备进行
测量。
通过双重绝缘或加强绝缘对
设备进行完全保护。
使用前请仔细阅读用户手册
以避免人身伤害和设备及其
所连接设备的损害。为避免危
险，请按说明正确使用。
探头与附件（辅助测试）组合
的测量等级是它们组合的较
低者。
请按照说明书正确使用探头；
否则，探头提供的保护将会降
低或消失。
IEC measurement category II is for measurements
performed on circuits directly connected to low voltage
installations. Examples are measurements on household
appliances, portable tools and similar equipment.
Equipment fully protected by D OUBL E INSUL ATION or
REINFORCED INSULATION.
Review this user manual carefully to avoid any personal
injury or damage to this product and any product
connected to it. To avoid potential hazards, use this
product only as specified.
The measurement category of a combination of a PROBE
ASSEMBLY and an accessory (an auxiliary to the
measurement) is the lower of the measurement
categories of the PROBE ASSEMBLY and of the accessory.
Follow the instructions to use the PROBE ASSEMBLY
properly. The improper use of the PROBE ASSE MBLY will
impair or ruin its self-owned protection function.
如您在使用此产品或本手册的过程中有
任何问题或需求，可与 RIGOL 联系：
If you have any problem or
requirement when using our products
or this manual, please contact RIGOL.
E-mail: service@rigol.com
Website:
Contact Us
www.rigol.com
探头零件清单
编号
名称
描述
数量 Quantity
两条装 Dual
单条装 One
○
Indicates a retractable hook
滑动开关
BNC 接头
附件说明 Accessories and Features
PVP2150 系列探头配有附件，使测试更为方便。请在使用前尽量熟悉下列说明，以便更好地使用。
PVP2150 is provided with several accessories designed to make probing and measurement simpler.
Please review the following instructions carefully in order to use the product properly.
1
Slide Switch
用于设置探头衰减比
Used to set the probe
attenuation ratio
No.
1 探头 Probe -- 2 1
2
○
3
○
4
○
5
○
6
○
7
○
Name
探头钩
Hook Tip
接地鳄鱼夹
Ground
Alligator
Clip
补偿调节棒
Adjustment
Tool
接地弹簧
Ground
Spring
绝缘保护帽
Insulation
Cap
标识环
Maker
Rings
Description
可伸缩的挂钩。
tip.
用于将探极可靠接地，便于安全操作和读取
正确的信号。Ensures the safe grounding of
the probe for safe operation and correct
signal reading.
用于调节探头补偿。Adjusts the pro be
compensation.
套在探头前端，用于 接地，可改善高频响应。
Attaches itself to the probe head for
grounding to improve high frequency
response.
遮盖探头前端金属裸漏部分，可防止漏电以
及确保使用者安全。Covers the exposed
metal part of the probe head to avoid
electricity leakage and protect the users.
将色环（黄、粉、浅蓝、深蓝）套置于线上，
可方便区分不同通道所用的探头。Attaches
itself (yellow, pink, light blue or dark blue)
to the probe cable to identify probes used in
different channels.
○
2 ○3 ○4
Accessory Kit
○
BNC Connector
连接至示波器测量通道
Connected to the oscilloscope
measuring channel
5
○
6
○
7
○
Probes Kit
2 1
2 1
1 1
2 2
2 1
8 8
Probe Kit
Loading...