Guangzhou Geliang Lighting Technology Co.,Ltd
Tel/Fax: +8620-86872001/2/3 Addr: No.61 , fengshen da dao , Xinhua street , Huadu district , Guangzhou , China
42 Leeds 3W RGB 3IN1 Indoor Par 5
4. Safety Instructions
We've put the device in advance transferred intact state. In order to maintain this condition and
ensure safe operation, the user absolute requirement to comply with the safety instructions and
warnings written in terms of manual species.
Important Notice: Due to neglect this manual caused damage within the scope of our responsibility.
Dealer is not responsible for failures and problems arising therefrom.
If the device has been exposed to temperature changes due to environmental changes, do not
switch it on immediately. The arising condensation could damage the device. Leave the device
switched off until it has reached room temperature. This device falls under protection-class I.
Therefore, it is essential that the device be earthed.
The electric connection must carry out by qualified person.
The device shall only be used with rate voltage and frequency
Make sure the power cord is never crimped or damaged by sharp edges .if this would be the case,
replacement of the cable must be done by an authorized dealer.
Always disconnect from the mains , when the device is not in use or before cleaning it .only handle
the power cord by the plug .Never pull out the plug by tugging the power cord
During initial start-up some smoke or smell may arise .this is a normal process and does not
necessarily mean that the device is defective, it should decrease gradually.
If the external flexible cable or cord of these luminaries is damaged, it shall be replaced
immediately.
5. Operation Instruction
Don’t turn on the fixture if it’s been through severe temperature difference like after transportation
because it might damage the light due to the environment changes .So make sure to operate the
fixture until it is in normal temperature.
This light should be keep away from strong shaking during any transportation or movement.
Don’t pull up the light by only the head, or it might cause damages to the mechanical parts.
Don’t expose the fixture in overheat, moisture or environment with too much dust when installing it.
And don’t lay any power cables on the floor. Or it might cause electronic shock to the people.
Make sure the installation place is in good safety condition before installing the fixture.
Make sure to put the safety chain and check whether the screws are screwed properly when
installing the fixture.
Make sure the fixture is operated by qualified personnel who know the fixture before using.
Keep the original packages if any second shipment is needed.
Don’t try to change the fixtures without any instruction by the manufacturer or the appointed
repairing agencies.