Guangzhou Geliang Lighting Technology Co.,Ltd
Tel/Fax: +8620-86872001/2/3 Addr: No.61 , fengshen da dao , Xinhua street , Huadu district , Guangzhou , China
RGBW 4in1 8W12Leds Outdoors Par Can Current 4 Page,Total 7Page(s)
5.3. AC Power
The fixture is designed to work on 100-240V 50/60Hz.Before applying power to a unit, check
that the source voltage matches the unit’s requirement.
6. Safety Instructions
This device has left the factory in perfect condition .in order to maintain this condition and to
ensure a safe operation, it is absolutely necessary for the user to follow the safety instructions
and warning notes written in this user manual
If the device has been exposed to temperature changes due to environmental changes, do
not switch it on immediately. The arising condensation could damage the device. Leave the
device switched off until it has reached room temperature. This device falls under
protection-class I. Therefore, it is essential that the device be earthed.
The electric connection must carry out by qualified person.
The device shall only be used with rate voltage and frequency
Make sure the power cord is never crimped or damaged by sharp edges .if this would be the
case, replacement of the cable must be done by an authorized dealer.
Always disconnect from the mains , when the device is not in use or before cleaning it .only
handle the power cord by the plug .Never pull out the plug by tugging the power cord
During initial start-up some smoke or smell may arise .this is a normal process and does not
necessarily mean that the device is defective , it should decrease gradually.
If the external flexible cable or cord of these luminaries is damaged, it shall be replaced
immediately.
7. Operation Instruction
The fixture is an LED wash light for onsite decoration purpose
Don’t turn on the fixture if it’s been through severe temperature difference like after
transportation because it might damage the light due to the environment changes .So make
sure to operate the fixture until it is in normal temperature.
This light should be keep away from strong shaking during any transportation or movement.
Don’t expose the fixture in overheat, moisture or environment with too much dust when
installing it. And don’t lay any power cables on the floor. Or it might cause electronic shock
to the people.
Make sure the installation place is in good safety condition before installing the fixture.
Make sure to put the safety chain and check whether the screws are screwed properly when
installing the fixture.
Make sure the lenses are in good condition. It’s recommended to replace the units if there
are any damages or severe scratch
Make sure the fixture is operated by qualified personnel who know the fixture before using.
Keep the original packages if any second shipment is needed.