Ridetech 41243000 User Manual

350 S. St. Charles St. Jasper, In. 47546
Ph. 812.482.2932 Fax 812.634.6632
www.ridetech.com
TGR14003 68-72 GM “A” Body TigerCage Shoulder Harness Bar
Shoulder Harness Bar 1 T136-1 Shoulder harness bar
2 T002 Clamp tabs
1 T037P TigerClamp P (threaded) 1 T038P TigerClamp P 1 T037D TigerClamp D (threaded) 1 T038D TigerClamp D 1 Tube of Anti-Seize
Hardware: 8 3/8” x 1” USS SHCS Clamps 2 ½” x 1 ½” 12 point Gr. 8 bolt Bar to clamp tab 2 ½” Flange nut Bar to clamp tab 4 ½” x 1 ½” USS gr. 8 bolt Shoulder harness 4 ½”USS Nylok gr. 8 nut Shoulder harness 8 ½” SAE flat washers Shoulder harness
TGR14003 Installation Instructions
Initial fitment of the floor mount brackets must be done under the carpet. Final installation can be done under or over the carpet.
Use Anti-Seize on all fasteners that are threaded into stainless clamps or brackets.
Install all bars before final tightening.
Always tighten the tab side of the clamp first.
Torque all 3/8” fasteners to 45 ft-lbs and all 1/2” fasteners to 75 ft-lbs.
Make sure the clamp is exactly where you want it before tightening as the clamp may scratch
the tubing.
Watch for fuel and brake lines when drilling holes through the floor pan.
1. In order to keep the “T” in the casting facing up, and the bolts facing the correct direction, there are two different direction clamps. Be very careful as to which clamp halves you are bolting together.
2. A correctly assembled clamp should look like the one in the picture shown to the left; there should be a
gap on one side for the tab to slide into.
3. Assemble the clamps to the main hoop just above the upper door bar clamp. Use clamp D on the driver side and clamp P on the passenger side. The bottom of the clamp should be 19” above the main hoop flange.
4. Use the ½” x 1 ½” 12 point bolt & flange nut to fasten the harness bar to the clamps.
Loading...