Ridetech 13044099 User Manual

350 S. St. Charles St. Jasper, In. 47546
Ph. 812.482.2932 Fax 812.634.6632
www.ridetech.com
Part # 13044099
Mopar LX Rear CoolRide Kit
Components:
2 90006781 267c air spring
1 90000713 Driver side upper air spring mount
1 90000714 Passenger side upper air spring mount
2 90000715 Lower air spring plate
Hardware:
10 99372002 3/8” USS Nylok nut Air spring mounts
4 99371003 3/8” x 1” USS bolt Upper air spring mount to car
4 99371017 3/8” x 3/4" button head Air spring to lower plate/ lower plate to arm
2 99373005 3/8” lock washer Air spring to lower plate
16 99373003 3/8” SAE flat washer Air spring mounts
2 99431001 7/16” x 1” USS bolt Lower plate to arm
2 99433002 7/16” SAE flat washer Lower plate to arm
2 99433003 7/16” lock washer Lower plate to arm
fastened with a 3/8” x 1” button head.
Installation Instructions
1. Raise the vehicle to a safe and comfortable working height with the suspension hanging freely.
2. Remove the factory shock absorbers and coil spring. Refer to a factory service manual for proper disassembly procedures.
3. Bolt the air spring to the lower plate use the 3/8” x 3/4” button head bolt, lock washer and flat washer.
4. Apply thread sealant to an elbow air fitting and screw it into the top of the air spring.
5. Fasten the upper mount to the air spring using two 3/8” Nylok nuts and flat washers.
6. The hole being tapped in the picture will be used to bolt the lower air spring plate; a 7/16” x 1” bolt, flat washer and lock washer will be used. A 7/16” USS tap will be needed.
7. The inside hole on the plate will
The button head must be used, a hex bolt could rub the air spring and cause failure. There is an existing hole in the lower arm.
8. Hold the air spring assembly up to the coil spring pocket. Using a camp to hold the bracket in place; center punch and drill the two mounting holes.
9. Secure the assembly with two 3/8” x 1” bolts, Nylok nuts and flat washers.
Note: The air line must be routed at this time.
14. Double-check air spring clearance through full suspension travel. Allowing the air spring to
rub will cause air spring failure and is not a warrantable situation.
15. Ride height on this air spring is 5” tall. This will be achieved at around 100psi but will vary to driver preference & vehicle weight.
Loading...