350 S. St. Charles St. Jasper, In. 47546
Ph. 812.482.2932 Fax 812.634.6632
www.ridetech.com
Part # 12141099
94-03 Mustang Front CoolRide Kit
2 90006781 Air springs – 6.5” diameter, double convoluted, ¼” port
2 90000346 Upper cup brackets (2 ¼” tall - Run airline toward inside of car)
1 90000361 Lower airspring mounting plate (pass. side)
1 90000360 Lower airspring mounting plate (drivers side)
Hardware:
2 99435004 7/16” x 4 ½” stud upper cup mounting (cut to 3 ½”)
2 99432001 7/16” Nylok nut upper cup mounting
2 99433002 7/16” SAE flat washer upper cup mounting
6 99371004 3/8” x 1 ¼” USS bolt lower mounting plates to a-arm
2 99371003 3/8” x 1” USS bolt lower airsping mounting
18 99373003 3/8” SAE flat washers 12 for lower plate mounting / 6 for airspring
10 99372002 3/8” USS Nylok nut 6 for lower plate mounting / 4 for airspring
2 99373005 3/8” lock washer lower airspring to plate
Installation Instructions
1. Raise the vehicle to a safe and comfortable working height, with the suspension
hanging freely.
2. Following the factory service manual instructions, remove the coil springs from the car.
3. Place the lower air spring plate on
top of the lower control arm. They are
labeled D for driver and P for
passenger.
4. The plate will be located by the
sway bar end link hole in the lower
control arm. The other three holes
must be drilled with a 3/8” bit and
fastened with 3/8” x 1 ¼” bolts, Nylok
nuts and flat washers.
5. Apply thread sealant to the a 90
degree air fitting and screw it into the
top of the air spring.
6. Place the upper cup bracket on top
of the air spring and secure with two
3/8” Nylok nuts and flat washers.
7. Cut 1” off of the 7/16” all thread
then screw it into the nut in the bottom
of the upper cup bracket.
8. Fasten the air spring assembly to
the frame in place of the coil spring,
using a 7/16” nut and flat washer. The
air fitting access should face toward
the engine. It may be easier to use a
needle nose pliers to get the nut
started on the stud.
Note: The airline must be routed at
this time.
9. Fasten the air spring to the lower
plate using a 3/8” x 1” bolt, lock washer
and flat washer.
10. Reattach the sway bar end link to
the lower control arm.
11. Check air spring clearance
through full suspension travel.
Allowing the air spring to rub will
result in failure and is not a
warrantable situation.
12. Ride height on this air spring is
approximately 5” tall. This may vary to
driver preference.
Loading...