350 S. St. Charles St. Jasper, In. 47546
Ph. 812.482.2932 Fax 812.634.6632
www.ridetech.com
Part # 12011099
49-51 Mercury Front CoolRide Kit
Components:
2 90006781 Air spring – 6.5” diameter, double convoluted, ¼” ports
2 90000269 Upper airspring mounts (4” tall)
2 90000270 Lower airspring mounts (2” tall angled)
Hardware:
2 99435002 7/16-14 x 8” stud upper airspring mount
6 99433002 7/16 sae flat washers upper airspring mount, lower shock mount
6 99432001 7/16 nyloc nuts upper airspring mounting stud, lower shock mount
4 99431002 7/16 x 1 ¼” uss bolts lower shock mounts
4 99372002 3/8 uss nyloc nuts upper airspring
6 99373003 3/8 sae flat washers airspring mounting
2 99371001 3/8 x 3/4 uss bolts lower airspring mounting
2 99373005 3/8 lock washers lower airspring mounting
This system is compatible with either stock or dropped spindles
1. Raise and support vehicle at a safe comfortable working level.
2. Remove coilspring. Refer to service manual for proper and safe procedure.
3. Assemble airspring onto its mounts. The tall cup is the top. The short angled cup goes
into the lower control arm with the tall part of the angle toward the spindle. This will
properly align the airspring when the vehicle is a ride height. The airline fitting, airline,
and the attachment stud will also be installed at this time.
4. Insert assembly into coilspring pocket. Route airline through an available existing
opening in the frame. Insert attachment stud through the oem shock hole.
NOTE: Coil spring pocket may need to be trimmed for clearance.
NOTE: IT IS THE FINAL RESPONSIBILITY OF THE INSTALLER TO ENSURE THAT THE
AIRSPRING BOES NOT RUB ON ANYTHING AT ANYTIME!
This is the airspring/bracket assembly at ride height, approximately 4.5-5.5” tall.
Loading...