350 S. St. Charles St. Jasper, In. 47546
Ph. 812.482.2932 Fax 812.634.6632
www.ridetech.com
Part # 11399100
S-10 Front MuscleBar
Components:
1 11399101 Sway bar kit (Includes the following)
2 Polyurethane frame bushing
2 Frame bushing strap
4 10mm x 1.5mm x 30mm flange bolt
4 90000924 10mm end link
8 90000717 Small T-bushing
2 90001092 Tube of Lithium grease
Hardware:
4 99112002 10mm x 1.5 Nylok nut PosiLink
2 99115001 10mm x 1.5 x 36mm stud (use Loctite)
Installation Instructions
*****This sway bar is designed for use with our front StrongArms*****
1. Apply lithium grease to the poly
bushings and slide them over the
sway bar.
2. Slide the bushing strap over the
bushing. Bolt the sway bar to the
frame using the 10mm x 30mm
bolts supplied.
Note: Some trucks did not come
with a factory sway bar. In this
case the holes may need to be
drilled and tapped.
3. Bolt the PosiLinks to the sway
bar and lower control arm. The
holes in the arm and bar are larger
than the PosiLink studs, so TÂbushing are supplied and must be
installed on the top and bottom of
the bar and the control arm tabs.
4. Check sway bar clearance
through full suspension travel and
from lock to lock.
Make sure that the PosiLinks do
not bind.
Loading...