350 S. St. Charles St. Jasper, In. 47546
Ph. 812.482.2932 Fax 812.634.6632
www.ridetech.com
Part # 11382899
99-06 Silverado Front Lower StrongArms
For Use w/ Shockwave or CoilOver
Components:
1 90000106 Driver side lower arm
1 90000107 Passenger side lower arm
2 90000901 Lower ball joint (includes boot, grease fitting, castle nut & cotter pin)
2 90000198 3” inner bushing sleeve
2 90000199 3.5” inner bushing sleeve
8 90001085 Poly bushing half
2 90000921 90 degree 12mm PosiLink
2 90000922 Straight 12mm PosiLink
2 90000095 PosiLink T Bushing
2 90000096 PosiLink Spacer
4 90002062 Aluminum shock spacer
4 99250001 ¼”-28 grease fitting – Use Lithium grease on frame bushings
Hardware:
2 99122003 12mm x 1.75 x 60mm stud PosiLink (Use Loctite)
4 99122001 12mm x 1.75 Nylock nut PosiLink
6 99433002 7/16” SAE Gr.8 flat washer PosiLink
2 99501024 ½”-13 x 3” Gr. 5 bolt Shock to lower arm
2 99502001 ½”-13 Nylok nut Shock to lower arm
1. After removing the factory lower
control arm, clean the bushing mounting
surfaces on the frame and lubricate with
Lithium grease.
2. Fasten the lower arm to the frame
using the factory hardware.
3. Slide the ball joint boot over the stud,
then push the stud down through the
spindle. Secure w/ the new castle nut
and cotter pin supplied.
4. Attach to the shock to the lower arm
using the ½” x 3” bolt and aluminum
spacers supplied.
5. Screw the Zerk fitting into the ball joint
and grease.
Sway bar
Control Arm Tab
Installation Instructions
Item #
Description
Qty.
1.
Driver side arm
1
2.
Inner bushing sleeve – 3”
1
3.
Inner bushing sleeve – 3.5”
1
4.
Poly bushing half
4
5.
Aluminum shock spacer
2
6.
½”-13 Nylok nut
1
7.
½”-13 x 3” Gr. 5 bolt
1
8.
Ball joint
1
9.
90 degree 12mm PosiLink
1
10.
Straight 12mm PosiLink
1
11.
PosiLink T Bushing
1
12.
PosiLink Spacer
1
13.
12mm x 1.75 x 60mm stud
1
14.
7/16” SAE Gr.8 flat washer
3
15.
12mm x 1.5 Nylok nut
1
99-06 Silverado CoolRide Driver Side StrongArm
Loading...