Ridetech 11370500 User Manual

Page 1
350 S. St. Charles St. Jasper, In. 47546
Ph. 812.482.2932 Fax 812.634.6632
www.ridetech.com
Part # 11370500
88-98 C-1500 Front Black Series Shock Kit
For Use w/ CoolRide
Components:
2 20000011 Shocks – Eye/Stud
2 MON32245 Hardware Kit
2 90001619 Cantilever Pin
2 90000471 Aluminum shock spacer
1 90002315 Drivers Side upper shock bracket
1 90002316 Passengers Side upper shock bracket
Hardware:
6 99371004 3/8” x 1-1/4” USS bolt Upper shock mount to frame
6 99372002 3/8” USS Nylok nut Air spring and shock mounting
12 99373003 3/8” SAE flat washer Air spring and shock mounting
Page 2
Installation Instructions
1. The large hole in the bracket will align with large hole in the frame. Using the bracket as a template, drill the remaining holes in the frame. Use 3/8” x 1 ¼” bolts, Nylok nuts and washers to secure the bracket. The inside of the frame can be accessed from the coil spring pocket to install the nuts.
Note: This bracket must be mounted BEFORE installing the air spring.
2. Drill a 5/8” hole in the rear leg of the lower control arm approximately 8 ½” from the mounting bolt. This can be moved slightly to achieve maximum tire clearance. Check tire clearance lock
to lock.
3. Attach the shock to the upper mount as shown in the picture.
4. Push the shock stud through the lower shock eye and aluminum spacer. Then through control arm and fasten with supplied nut. This picture is shown with the optional StrongArm installed.
Loading...