350 S. St. Charles St. Jasper, In. 47546
Ph. 812.482.2932 Fax 812.634.6632
www.ridetech.com
Part # 11369100
63-87 C-10 Front MuscleBar
For use with StrongArms only
Components:
1 90000664 Sway bar (includes the following)
2 Polyurethane frame bushing
2 Frame bushing bracket
2 90000921 12mm 90 degree PosiLink
2 90000922 12mm straight PosiLink
2 99125001 12mm x 1 ¾” all thread to attach swivel end links (use Loctite)
Hardware Kit: 99010050
4 99122001 12mm Nylok Jam nuts for swivel end links
8 99433002 7/16” flat washers for end links
4 99371004 3/8” x 1 ¼” USS bolt for frame bracket
4 99372002 3/8” USS Nylok nut
8 99373003 3/8” SAE flat washer
11369100 Installation Instructions
3. For 73-87
Bolt the new MuscleBar to the frame
rail using the poly bushing and bracket.
The rear hole for the factory sway bar
mount will be reused for the rear hole
in the new bracket. The front hole
must be drilled with a 3/8” bit. Four
3/8” x 1 ¼” bolts, Nylok nuts, and eight
flat washers will secure it to the frame.
3. For 63-72
Clamp the mount 2 ¾” behind the
oval hole in the bottom of the frame.
Both of the holes for the sway bar
mount must be drilled with a 3/8” bit.
Secure the mount with four 3/8” x 1
¼” bolts, Nylok nuts and flat washers.
1. This sway bar is designed for use with RideTech lower StrongArms. It will not work
with other arms without modification.
2. Remove the factory sway bar. On trucks with a factory sway bar you will have to remove the
sway bar frame mount.
4. Install the end link to the sway bar
and lower arm as shown in the picture.
It will be fastened with 12mm jam nuts
and flat washers.
Loading...