Page 1
350 S. St. Charles St. Jasper, In. 47546
Ph. 812.482.2932 Fax 812.634.6632
www.ridetech.com
Part # 11360602
73-87 C-10 Master Series DA Front Shock Kit
For Use w/ Lower StrongArms
Shock Assembly:
2 21239999 3.5” stroke Master Series double adjustable shock
6 90001632 Compression bump stop
2 90001834 Short Stud top – 2”
2 90001686 .625” bearing
2 90001900 Snap ring for bearing
Components:
2 90001906 Stud top base
2 90001902 Aluminum cap for Delrin ball
2 90001903 Upper Delrin ball half
2 90001904 Lower Delrin ball half
2 90001619 Cantilever pin w/ hardware
4 90002042 Aluminum bearing spacer - .625” I.D.
2 90000471 Aluminum spacer
1 90002303 Driver side upper shock bracket – bolt-on
1 90002304 Passenger side upper shock bracket – bolt-on
Hardware:
8 99371004 3/8” x 1 ¼” USS bolt Upper shock bracket to frame
8 99372002 3/8” USS Nylok nut Upper shock bracket to frame
16 99373003 3/8” SAE flat washer Upper shock bracket to frame
2 99623001 5/8” SAE flat washer Cantilever pin
4 99562002 9/16” SAE jam nut Upper shock stud
Page 2
Installation Instructions
1. Place the new upper shock mount
against the frame, the tab in the front of
the bracket will slide into the factory
shock stud hole. Position the bracket
so that the bottom of the bracket is
parallel to the bottom of the frame.
Using the bracket as a template, mark
an drill four 3/8” holes in the frame rail.
Secure the bracket to the frame using
four 3/8” x 1 ¼” bolts, Nylok nuts and
flat washers.
2. Attach the shock to the upper
mount. See diagram on following
page.
3. Attach the shock to the lower
control arm using the cantilever pin
supplied. See diagram on following
page.
Page 3
Upper Shock Stud Assembly
1. 90001834- Short Delrin stud top base – 2”
2. 90001904- Delrin ball lower half
3. 90001903- Delrin ball upper half
4. 90001902- Aluminum cap for Delrin ball
5. 99562002- 9/16” SAE jam nut
6. 90001906- Short Delrin stud top – 2”
7. Black adjustment knob
8. Detent clip
9. Screw
10. Washer
Cantilever Pin Assembly
1. Cantilever Pin
2. 5/8” SAE Washer
3. Aluminum Bearing Spacer
4. .625” Bearing
5. Aluminum Bearing Spacer
6. Control arm tab
7. ½” Lock Washer
8. ½” SAE Nut
Page 4
Loading...