Ridetech 11330607 User Manual

350 S. St. Charles St. Jasper, In. 47546

Ph. 812.482.2932 Fax [phone]

www.ridetech.com

Part # 11330607

63-72 C-10 Select Series Front Shock Kit

For Use w/ Lower StrongArms

Shock Assembly:

2 26439999 3.5” stroke Select Series shock

2 90001632 Compression bump stop

Components:

2 90001831 Stud top base

2 90001905 Step washer for Select shocks

2 35900006 Harness - Shocks to Select ECU

2 35900008 Harness – Stud adapter

4 90001830 Aluminum cap for Delrin ball

2 90001903 Upper Delrin ball half

2 90001904 Lower Delrin ball half

2 90001619 Cantilever pin w/ hardware

4 90002042 Aluminum bearing spacer - .625” I.D.

1 90002301 Driver side upper shock bracket – bolt-on

1 90002302 Passenger side upper shock bracket – bolt-on

Hardware:

8 99371004 3/8” x 1 ¼” USS bolt Upper shock bracket to frame

8 99372002 3/8” USS Nylok nut Upper shock bracket to frame

16 99373003 3/8” SAE flat washer Upper shock bracket to frame

2 99623001 5/8” SAE flat washer Cantilever pin

2 99122001 12mm Nylok nut Upper shock stud

Installation Instructions

1. Place the new upper shock mount
against the frame, the tab in the front of
the bracket will slide into the factory
shock stud hole. Position the bracket
so that the bottom of the bracket is
parallel to the bottom of the frame.
Using the bracket as a template, mark
an drill four 3/8” holes in the frame rail.
Secure the bracket to the frame using
four 3/8” x 1 ¼” bolts, Nylok nuts and
flat washers.

2. Attach the shock to the upper
mount. See diagram on following
page.

Note: A notch must be made in the
inner fender well just above the mount
to allow clearance for the shock stud.

3. Attach the shock to the lower
control arm using the cantilever pin
supplied. See diagram on following
page.

Upper Shock Stud Assembly

1. 90001831- Short Delrin stud top base – 2”

2. 90001905- Step washer (Step faces down)

3. 90001902- Aluminum cap for Delrin ball

4. 90001904- Delrin ball lower half

5. 90001903- Delrin ball upper half

6. 99122001- 12mm Nylok nut

7. Harness retaining nut

Cantilever Pin Assembly

1. Cantilever Pin

2. 5/8” SAE Washer

3. Aluminum Bearing Spacer

4. .625” Bearing

5. Aluminum Bearing Spacer

6. Control arm tab

7. ½” Lock Washer

8. ½” SAE Nut