Ridetech 11289000 User Manual

350 S. St. Charles St. Jasper, In. 47546

Ph. 812.482.2932 Fax [phone]

www.ridetech.com

Part # 11289000

65-70 Impala Panhard Bar Kit

Components:

1 90000998 Panhard bar – TW 33.875” (C-C 35.75”)
1 90001942 Rubber bushing – Pressed into panhard bar
1 90001946 Kevlar lined Heim end - .75” thread x .75” I.D.
1 99752004 3/4”-16 SAE jam nut
2 90000724 Aluminum T-bushing
1 90000461 Panhard bar axle stud

Hardware:

1 99622006 5/8” SAE Nylok jam nut Panhard bar stud
1 99561003 9/16” x 3” SAE Gr. 8 bolt Panhard bar to frame
2 99562001 9/16” SAE Nylok jam nut Panhard bar
1 99563001 9/16” USS flat washer Panhard bar stud
1 99603003 5/8” USS flat washer Panhard bar stud

1. Replace the factory panhard bar
with the new one using the new
stud and hardware supplied. The
rubber rod end will be attached to
the axle.

2. The Heim end will attach to the

frame using the 9/16” x 3” bolt and

Nylok nut. Two aluminum T­bushings need to be installed on
each side of the Heim end.

3. The panhard bar should be

approximately 35 ¾” center eye to

center eye, but may need adjusted
to center the axle. This should be
checked at ride height.

Installation Instuctions