Ridetech 11284699 User Manual

350 S. St. Charles St. Jasper, In. 47546

Ph. 812.482.2932 Fax [phone]

www.ridetech.com

Part # 11284699

65-70 Impala Rear CoolRide

For Use w/ Lower StrongArms

Components:

2 90006781 267c Air spring

2 90000024 Upper air spring bracket

2 90000224 Upper bracket frame washer

Hardware:

2 99435001 7/16 x 6” stud Upper air spring bracket to frame

2 99432001 7/16” USS Nylok nut Upper air spring bracket to frame

2 9943002 7/16” flat washer Upper air spring bracket to frame

2 99372001 3/8” USS Nylok nut Air spring to upper bracket

2 99371001 3/8” x 3/4" USS bolt Air spring to lower arm

6 99373003 3/8” flat washer Air spring

2 99373005 3/8” lock washer Air spring to lower arm

*** For use w/ RideTech shock kit ***

1. Apply thread sealant to an
elbow air fitting and screw it into the
top of the air spring.

2. Place the upper air spring
bracket on top of the air spring
clocked so the air fitting access
hole is next to the fitting. Fasten it
to the air spring using two 3/8”
Nylok nuts and flat washers.

3. Screw the 7/16” x 6” all thread
into the nut at the bottom of the
bracket.

4. Place the upper washer on top
of the coil spring pocket.

5. Raise the assembly into the coil
spring pocket with the all thread
sticking through the upper washer.
Secure the assembly with a 7/16”
Nylok nut and flat washer.

6. Fasten the air spring to the
lower arm using a 3/8” x 3/4" bolt,
flat washer and lock washer.

7. Double check air spring
clearance through full suspension
travel.

8. Ride height on this air spring is
approximately 5” tall. This may
vary to driver preference.