350 S. St. Charles St. Jasper, In. 47546
Ph. 812.482.2932 Fax 812.634.6632
www.ridetech.com
Part # 11019100
55-57 Chevy Front MuscleBar
Components:
1 90000731 Sway Bar
2 90001100 Bushing and strap kit
2 90000729 Frame plate
4 90000717 Aluminum step washer
2 90000924 10mm straight PosiLink
2 90000926 10mm 90 degree PosiLink
1 90001092 Tube of lithium grease
2 99115001 10mm x 1.5 stud In PosiLink (use Loctite)
Hardware Kit: 99010047
2 99115006 10mm lock washer 90 degree PosiLink
2 99112002 10mm Nylok nut Straight PosiLink
8 99371005 3/8” x 1 ¼” USS bolt Frame plate
8 99372002 3/8” USS Nylok nut Frame plate
18 99373003 3/8” SAE flat washers Frame plate & PosiLink
PDF created with pdfFactory trial version www.pdffactory.com
11019100 Installation Instructions
This sway bar is designed for use with Air Ride Technologies StrongArms.
1. The sway bar frame plate will
index off of this factory support
brace rivet. Remove the rivet by
grinding the head smooth, then
drive it out with a hammer and
punch.
2. Drill hole to 3/8”.
3. Using a 3/8” x 1 ¼” bolt, flat
washer and Nylok nut, bolt the
frame plate to the bottom of the
frame rail.
4. Make sure the side of the plate
is aligned with the outside of the
frame rail. Drill the remaining
holes.
5. Bolt the outside rear hole of the
plate to the frame using a 3/8” x 1
¼” bolt, Nylok nut and flat washer.
PDF created with pdfFactory trial version www.pdffactory.com
6. Apply lithium grease to the poly
bushing. Install the bushing over
the sway bar, and then place the
bushing strap over the bushing.
7. Bolt the sway bar to the frame
plate using two 3/8” x 1 ¼” bolts,
Nylok nuts and flat washers. Do
not tighten yet.
8. Bolt the 90 degree end of the
PosiLink to the sway bar. A 3/8” flat
washer and 12mm lock washer
must be installed between the
PosiLink and the bar.
9. Bolt the straight end of the
PosiLink to the lower control arm.
An aluminum step washer must be
installed on each side of the control
arm tab. Fasten with a 12mm
Nylok nut. Then tighten the
bushing frame bolts.
PDF created with pdfFactory trial version www.pdffactory.com
Your MuscleBar installation is now
complete. If you have any further
questions, please call our technical
support line at 812-482-2932.
Loading...