Ricoh Table760 Technical Bulletin
T
echnical
B
ulletin
PAGE: 1/2
Model:
Subject:
From:
Classification:
Copy Tray Type 760S (A836-11) has been introduced as an additional option for the J2SS
II multiple version copier (A252). Copy Tray Type 760 (A836-10) has already been
launched. So, there are now two copy trays that can be installed on the A252 copier.
J2SS II
Copy Tray Type 760S Introduction
GTS and S Field Information Dept.
Troubleshooting
Mechanical
Paper path
Other (New product informaiton)
Part information
Electrical
Transmit/receive
Date:
15-Oct-98
Prepared by:
No.:
8
H. Kobayashi
Action required
Service manual revision
Retrofit information
Differences between Type 760 and Type 760S
1. Type 760S requires less space for installation than Type 760 (A836-10).
The space required at the rear side of the copier is as follows:
Type 760: 589 mm
Type 760S: 180 mm
2. When paper longer than A0/E size (1200 mm) is stacked on a Type 760S tray, a part
of the paper may touch the floor because of its more compact size.
Installation Procedure
The following shows the different steps from the Type 760.
a) Accessories and Step #7
The following parts are not necessary, so they are not accessories and Step 7 of the
procedure is not required.
Rear Copy Tray Sheet – Short [B]………………………………………. 2
Rear Copy Tray Sheet – Center [A]………………………………………1
[B]
[A]
[B]
[A]
T
echnical
B
ulletin
PAGE: 2/2
Model:
b) Step #5
J2SS II
Only the configuration of the rear copy trays [E] in the illustration is different from the
Type 760 to reduce the installation space.
The new part numbers are listed in MB No.1 for the Table & Copy Tray for the J2SSII.
Type 760
[E]
[F]
[G]
Date:
15-Oct-98
No.:
8
Type 760S
[E]
[D]
Loading...