Ricoh sr85 Installation Manual
Installation Manual
Bookletmaker SR 85 and Trimmer TR 85
August 2000
Part nr. 75653
Introduction
This install manual covers the installation of the Booklet maker SR 85 and the Trimmer TR 85.
If you have any comments or remarks, please contact us on
one of the following numbers:
Email: support.oem@plockmatic.se
Phone: +46 8 602 50 41
1 800 648 57 73
Fax: +46 8 722 9970
Installation manual SR85
Page 2
Table of contents
1. Minimum space requirements
1.1 Space requirements
2. Installing the Bookletmaker
2.1 Unpacking
2.2 Power requirements
2.3 Installing the infeeder
2.4 Preparing the printer
2.5 Interface
2.6 Wiring communication cable
2.7 Connectors communication cable
2.8 Adjustments
3. Installing the Trimmer
3.1 Unpacking
3.2 Power requirements
3.3 Attaching the Trimmer to the Bookletmaker
Page
1-1
2-1
2-2
2-3
2-3
2-6
2-7
2-8
2-9
3-1
3-2
3-2
Installation manual SR85
1. Minimum space requirements
1.1 Space requirements
1. Ensure that the minimum required floor space is available for an installation of the
Bookletmaker SR 85 including the Trimmer TR 85 as shown in figure 1.
Installation manual SR85
Figure 1
1-1
2. Installing the Bookletmaker
2.1 Unpacking
1. Remove all parts from the pallets.
2. Unpack installation kit.
Box 1 containing: 1. Base
Box 2 containing: 1. EPROM
2. Exit arm catcher
3. Template
4. Connection cable
5. Powercord
6. Shift tray plate with four 5.5 mm x 6 counter screws.
7. Exit tray plate with four 5.5 mm x 6 screws.
8. Docking assembly for the printer with two screws.
9. Docking assembly for the Bookletmaker with four MRX
7 mm x 8 screws.
10. Tapping cabel
Pipe 1 containing: 1. Front panel
2. Rear panel
3. Shelf
Pipe 2 containing: 1. Infeeder assembly
3. Ensure all of the packaging material is removed from the outside of the
Bookletmaker.
4. Take the base (1) and turn it up side down and install the docking assembly (2)
with four 7 mm screws. Turn the base around and put it on the floor. Take the
Bookletmaker (3) and install it on the base, according to figure 2. (The four screws
on the Bookletmaker fits in the four holes on the base).
3
2
1
Installation manual SR85
Figure 2
2-1
2.2 Power Requirements
Bookletmaker With Trimmer
Configuration Nom. Voltage (V) Max. Current (A) Max. Current (A)
Europe 220/230/240 0.5 A 2.0 A
N&S America 105/11 5/125 1.0 A 4.0 A
1. Remove the right cover (1) by loosen two 8 mm screws, figure 3.
1
Two 8 mm screws
Figure 3
2. Check wall outlet voltage.
3. Check the transformer (2) tapping for the correct configuration, figure 4.
(Machines are tapped for 230V or 115V depending on configuration)
2
4. Reinstall the right cover.
Installation manual SR85
Figure 4
2-2
Loading...