To ensure the grounding of the rear cover, two screw holes have been added
at the bottom of the rear cover and a grounding plate has been added to the
Upper Rear Cover Holder.
Inter-
change-
ability
X/X273PS280 / 290
X/X73PS270
X/O17
Upper Rear Cover Holder
1 → 1
1 → 1
2 → 2
Parts Catalog
Index No.Page
Date of
Modification
Serial Number
The interchangeability of old the both and new rear covers is X/X, because the bracket for the screws that secure the rear
cover at the bottom has also been added to the base plate of the machine. The base plate is not a service part.
T. Inoue, General Manager
1st Field Information Dept. QAC
Modified ArticlePaper TalonNo serial number cut-in information
The Paper Talon has been added on the paper tray to prevent SC codes
Reason for
Modification
Old P/NNew P/NDescriptionQ’ty Used
E501 - E506 when paper falls to the rear side of the tray and blocks the lift
mechanism.
The tray # A134 2953 is the tray with the Paper Talon.
Part numbers have been assigned for the Paper Tray and the Paper Talon.
A134 2953Paper Tray
A134 2960
Paper Talon
0 → 1
0 → 1
Inter-
change-
ability
-----1811
-----1911
Index No.Page
Date of
Modification
Parts Catalog
Serial Number
Paper Tray
Paper Talon : A134 2960
T. Inoue, General Manager
QAC 1st Field Information Dept.
Page 10
RICOHModification BulletinPAGE: 1/1
from 1.6 mm to 1.2 mm
Model: PS280 / PS290Date: 15-Apr-97
No: 7
Modified Article: Tray Bottom Lift Shaft / LeverPrepared by: S.Hizen
From: QAC 1st Field Information Dept.Checked by: T. Inoue
Reason for
Modification:
Parts catalog correction
To facilitate assembly
Part standardization
These parts are interchangeable as a set. ( o/o as a set )
The thickness of this plate has been changed
∗
∗
The flat part of the shaft has
been eliminated
Page 11
RICOHModification BulletinPAGE: 1/1
Model: PS280/290Date: 31-May-97
No: 8
Modified Article: Paper Tray & Side FencesPrepared by: S.Hizen
From: QAC 1st Field Information Dept.
Reason for
Modification:
Parts catalog correction
To facilitate assembly
Part standardization
Vendor change
To improve reliability
Other
To meet standards
( )
The following parts have been changed to standardize with the Phoenix Mark 2.
This modification is also to secure both fence positions with screws.
Old partNew partDescriptionQtyIntPageIndex Note
AF016080AF016084Front Side Fence1-1X/X113*¬-
A1342953A2042953Paper Tray1-1X/X1118*¬
AF016081AF016085Rear Side Fence1-1X/X1111*¬-
Note:
¬ The interchangability of these three parts as a set is X/O.
- Both old side fences are still available as service parts.
The start serial number cut-ins are as follows:
MODEL
NAME
PS 290115/ 60USA, CanadaA549- 153A17040001
PS 290220, 240/ 50