Ricoh ap4500 INSTALLATION GUIDE

PS430

(Code: G520)

For Machine Code: G035

INSTALLATION GUIDE

Important

❒ Confirm a code by the nameplate of the printer.

Caution

•

Before installing options, the machine should be turned off and unplugged for
at least thirty minutes. Components inside the machine become very hot, and
can cause a burn injury if touched.

•

Before moving the machine, unplug the power cord from the outlet. If the cord
is unplugged abruptly , it could become damaged. Damaged plugs or cords can
cause an electrical or fire hazard.

•

When lifting the machine, use the grips on both sides. The machine could break
or cause an injury if dropped.

Confirm that the printer is turned off, and pull the plug out
of the wall outlet.

○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○

Remove the tape that holds the paper bank, and remove
the packing material.

TAPP800E

Align the printer over the paper bank, and then lower it
gently onto the paper bank.

○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○

TAPP021E

Important

❒ When lifting the printer, pull out the grips from the front side

of the printer . Hold the front side grips, and hold the inset grips
on the rear side.

❒ The printer should be held by at least two people.

TAPP810E

Remove the screw, knob screw and lock plate from inside
the packing material.

1

2

3

TAPD011E

1. Screw

2. Knob Screw (Finger type)

3. Lock Plate

TAPH120E

Push the grips into the printer. Take out the cover inside
the Tray 2 and attach it between the paper tray and the
front cover.

TAPP040E

G520-8610

Pull the second paper tray (Tray 2) up until it stops. After
that, lift it slightly, then pull it out.

○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○

TAPH210E

Open the lower vertical paper feed cover on the right side

a

of the paper bank (
hole inside (

○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○

screw using your fingers.

b

). Hang the lock plate hook in the

), and then fasten the plate with the knob

Pull out the first paper tray (Tray 1), and take the

a

screwdriver (

) from the tray.

TAPP720E

Note

❒ Be sure to return the screwdriver to the paper tray after using

it.

Lock the paper bank and the printer with the screw.

TAPP050E

Close the lower vertical paper feed cover.

Open the connector cover, and attach the connector
cables.

TAPP060E

Close the connector cover.

TAPP031E

Replace the second paper tray (Tray 2) into the printer.

TAPH221E

TAPP070E

Note

❒ Print a configuration page to confirm that the paper bank is

properly installed. For instructions on how to print a
configuration page, see “Printing the Test Page” in the “Operating
Instructions” that comes with the printer .

Printed in Japan Copyright© 1999 G520-8610