echnical Bulletin
T
PAGE: 1/1
Model:
Subject:
From:
Fresa Win+
Incomplate Toner Fusing
Technical Services Dept., GTS Division
Classification:
Troubleshooting
Mechanical
Paper path
Other ( )
Part information
Electrical
Transmit/receive
Date:
12-Mar-01
Prepared by:
No.:
RG047001
Y. Tamaoka
Action required
Service manual revision
Retrofit information
SYMPTOM
Incomplete toner fusing or reduced glossiness may occur with the first print made after the
machine recovers from Energy Saver Mode. This tends to occur more with plain (standard)
paper that is relatively thick.
CAUSE
When the machine starts printing after coming out of Energy Saver Mode, the hot roller
temperature is not high enough to ensure proper fusing for the first print.
SOLUTION
A special version of the MCU firmware has been released.
Version : 9.00
CheckSum : 4DB4
With this version, the hot roller temperature for the first print out of Energy Saver Mode is
increased by 10°C over the usual temperature.
Note
1. It takes slightly longer to get the first print with this firmware version because of the
above reason.
2. This MCU firmware contains the “Charger Cleaning Alert” feature. Therefore, the
controller firmware needs to be updated to version 3.20 or newer. Please refer to RTB
RG24015.
echnical Bulletin
T
PAGE: 1/1
Model:
Subject:
From:
Classification:
Firmware history for the FresaWIN+ RPS2.
FresaWin+
ROM History (FresaWIN+ RPS2)
Technical Services Dept., GTS Division
Troubleshooting
Mechanical
Paper path
Other ( )
Suffix Version Check Sum Production
G5035921
B 3.10 34CF November Prod. 2000
C 3.55 ACA8 June Prod. 2001
Part information
Electrical
Transmit/receive
Date:
Symptom Corrected
Overflow error in the coordinate variable.
An internal error appears when trying to cancel a job using the
Reset key.
Item header "B" of RPS2 menu is omitted.
Previous Changed to
B.Job Timeout C.Job Timeout
C.I/O Tomeout D.I/O Timeout
--- ---
18-May-01
Prepared by:
Action required
Service manual revision
Retrofit information
C
C
B
No.:
H. Someya
RG047002