Ricoh A384 Modification Bulletin RFC830

MODIFICATION BULLETIN NO. 1

PAGE 1 OF 4

ISSUED ON: July 31, ’94

Model

J3 Roll Feeder Connector

Volt/Hz

Date of

Serial

Modification

Number

Modified Article

Right & Left Release Levers

Reason for

To ensure the front cover is locked

Modification

Draw

Old Parts

New Parts

Q’ty Used

Inter-

Parts needed for replacement by new part

Parts

Description

Rank

change-

Catalog

No.

No.

No.

Old→New

Part No.

Description

No.

Page

ability

A4532603

A4532604

Left Release Lever

1 → 1

X/X

4

3

A4532613

A4532614

Right Release Lever

1 → 1

X/X

15

3

03130060B

Philips Pan Head Screw - M3

n → n-2

102

3

x 6

09513006B

Philips Screw With Flat

n → n-4

104

3

Washer - M3 x 6

Rank: A : Replace with new parts immediately. B : Replace with new parts at time of repair. Interchangeability:

C : Replace with new parts at time of overhaul.

(1)When old and new parts are not mutually interchangeable, use additional parts or an assembly part as indicated in "Parts needed for replacement by new part" to install the new part.

(2)The mark to the left of the slash indicates whether the old part can be used in the new machine, and the mark to the right indicates whether

the new part can be used in the old machine. x = Not interchangeable o = Interchangeable

MODIFICATION BULLETIN NO. 1

PAGE 2 OF 4

ISSUED ON: July 31, ’94

DETAILS OF MODIFICATION
					When the sheet feeder is pushed in roughly,
12.5	9		24	9	the front cover may sometimes be released
M3	15.5	2-M3	8.5 15.5		due to the tolerance of the length of the front
					cover lock shaft.
Lock Shaft - Front Cover					To correct this, the production machines have

been modified so that the left and right release bracket position can be adjustable.

1. A screw hole has been added to the front cover lock shaft.

2. The configurations of the left and right release lever has been changed as shown.

Left Release Lever

Right Release Lever