Ricoh 9120A User Manual

MP9120A SPECIFICATIONS

COMPACT DISC Recordable/ReWritable

&

DVD-ROM DRIVE

MP9120A

SPECIFICATIONS

(Preliminary)

RICOH Company, Ltd.

May 2, 2000
DRC-603-807

(May 2, 2000) I - 1  (Preliminary)

MP9120A SPECIFICATIONS

NOTICE

This equipment has been tested and found to comply with the limits for a Class B digital
device , pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates , uses and can radiate radio frequency energy and , if not installed and
used in accordance with the instructions , may cause harmful interference to radio
communication.
However , there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception , which can
be determined by turning the equipment off and on , the user is encouraged to try to correct
the interference by one or more of the following measures :

---Reorient or relocate the receiving antenna.

---Increase the separation between the equipment and receiver.

---Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.

---Consult the dealer or an experienced radio / TV technician for help.

FCC WARNING

Changes or modification not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.

CAUTION

Use of controls or adjustments or performance of procedures other than those specified
herein may result in hazardous radiation exposure.

a) Pay careful attention not to let the invisible laser beam emitted from the optical pickup enter

into your eyes.

b) When you find a troubled state of the component in the optical pickup containing the laser

diode , change to the specified new optical pickup. Do not open the optical pickup housings.

(May 2, 2000) I - 2  (Preliminary)

MP9120A SPECIFICATIONS

Akustischer Geräuschpegel

Dieser Drucker überschreitet einen Geräuschpegel von 70 dB (A) während dem Betrieb
nicht.

Declaration of Conformity
“The Product complies with the requirements of the EMC Directive 89/336/EEC
and the Low Voltage Directive 73/23/EEC.”

(May 2, 2000) I - 3  (Preliminary)

MP9120A SPECIFICATIONS

Revision History

No. Revised Data Revision Contents Description Page

1 May 2, 2000 Preliminary

(May 2, 2000) I - 4  (Preliminary)