Rice Lake SURVIVOR LaserLight User Manual
LaserLight
™
Remote Display
Pole Mount Installation Instructions
PNs 75850, 75852
This document contains drawings, replacement parts
lists, and instructions for installing the optional pole
mount for the 4" and 6" LaserLight remote displays.
See the LaserLight Installation Manual , PN 75936 for
general installation and configuration and calibration
information.
LaserLight
Remote Display
Caution
Used for 6"
model
The LaserLight has no on/off switch.
Before working with the unit, ensure the
power cord is disconnected from the
power outlet.
Pole
Mounting
Weldment
Used for 6"
model
Figure 1. Optional Pole Mount Kit
The LaserLight remote display can be easily mounted to a pole or steel I-beam using the optional pole mounting
weldment and clinching brackets (shown in Figure 1).The pole mounting kit can accomodate either the 4" or the
6" LaserLight. Use the following steps to install the pole option.
1. Use the enclosed 3/8" cap screws, washers, and lock nuts from the parts kit to attach the clinching pole
brackets to the pole mounting weldment. Note that two clinching pole brackets are used for the 4"
models and are attached to the pole mounting weldment using the center holes. Six inch LaserLights
utilize four clinching pole brackets and are connected using the top and bottom hole alignments.
2. Use the enclosed 3/8-16NC bolt (PN 14747) to attach the clinching pole brackets together using washers
and lock nuts. Tighten as necessary.
3. Align the back of the LaserLight remote display to the pole mount weldment so that the holes line up.
4. Use enclosed 1/4" cap screws, washers, and nuts to attach the remote display to the mounting weldment.
Clinching
Pole Brackets
June 2003 78040
2
Parts Kit Contents
Table 1 lists the parts kit contents for the pole mount option for the LaserLight remote display.
Model
4" 6"
77000 76998 Pole mounting weldment (1)
14635 Lock nuts, 1/4-20NC (4)
14747 Bolt, 3/8-16NC x 2 - 3/4 (1 - 4" model) (2 - 6" model)
14955 Cap screws 1/4-20NC x 1/2 (4)
15019 Cap screws, 3/8 - NC x 1 (2 - 4" models) (4 - 6" models)
15145 Washers 1/4 Type A (8)
21938 Washers 3/8 Type A (6 - 4" model) (12 - 6" model)
22072 Lock nuts, 3/8 - 16NC (3 - 4" model) (6 - 6" model)
76999 Clinching pole bracket (2 - 4" model) (4 - 6" model)
77001 Machine screws 3/8 - 16NC x 6 (3 - 4" model) (6 - 6" model)
Description
Table 1. Parts Kit Contents
LaserLight Pole Mount Option Installation Instructions
Loading...