Rheem Value Series 80 AFUE Single-Stage PSC Motor Submittal Sheet
FEATURES FOR RGPS-
• Unique solid door design leads to quiet operation.
• Patented heat exchanger, constructed of both stainless and
aluminized steel for the maximum in corrosion resistance.
• Low profile “34 inch” [864 mm] design is lighter and easier to
handle, and leaves room for optional equipment.
• Convertible from upflow to horizontal left or right without field
conversion.
• Left or right side gas and electric inlet connections allow quick
and simple change.
• Direct spark ignition with remote sense, features a new
integrated board with an electronic air cleaner hookup.
• A slow-open gas valve and a specially designed draft inducer
motor make it one of the quietest furnaces on the market
today.
• Grab-holes in doors to aid in easy door removal and
replacement.
• Prepaint galvanized steel cabinet.
✝A.F.U.E. (Annual Fuel Utilization Efficiency) calculated in accordance with Department of Energy test
procedures.
FIELD INSTALLED ACCESSORIES
Internal Filter Rack for Bottom or Side Return (RXGF-DA*) ....
Side Return Filter Rack (RXGF-CA) ........................................
Bottom Return Filter Rack for Upflow Application (RXGF-CB)
Twinning Kit (RXGP-F03)..........................................................
Fossil Fuel Kit (RXPF-F01 and F02) ........................................
Return Air Cabinets (RXGR-C**B)............................................
Solid Bottom Kit (RXGB-D14, 17, 21, 24) ................................
FORM NO. X66-1255 REV. 1
Supersedes Form No. X66-1255
JOB NAME MODEL NO.
CONTRACTOR OUTDOOR UNIT MODEL NO.
ENGINEER LOCATION
SUBMITTED FOR APPROVAL RECORD ORDER NO.
DATE
SUBMITTAL SHEET FOR RGPS80% A.F.U.E.
✝
UPFLOW/HORIZONTAL GAS FURNACES
Models with Input Rates from 50,000 to 150,000 BTU/HR
[15 to 44 kW].
UNIT DATA
HEATING PERFORMANCE
TOTAL CAPACITY INPUT* ......
_______
MBH [kW]
TOTAL CAPACITY OUTPUT* ..
_______
MBH [kW]
DESIGN TEMP. RISE ..............
_______
°F [°C] DB
AFUE ................................................
_______
%
CALIFORNIA SEASONAL
EFFICIENCY ..................................
_______
%
(*uses blower motor heat)
SUPPLY AIR BLOWER PERFORMANCE
TOTAL AIR SUPPLY ................
_______
CFM [L/s]
TOTAL RESISTANCE EXTERNAL
TO UNIT......................................
_______
IWG
BLOWER SPEED ..........................
_______
RPM
POWER OUTPUT REQUIREMENT ..
_______
BHP
MOTOR RATING ........................
_______
HP [W]
POWER INPUT REQUIREMENT ........
_______
kW
ELECTRICAL DATA
POWER SUPPLY ........................
__________ Hz
TOTAL UNIT AMPACITY................
_______
AMPS
MINIMUM WIRE SIZE ....................
_______
AWG
MAXIMUM OVERCURRENT DEVICE
FUSES/HACR BREAKER ..........
_______
AMPS
UPFLOW DIMENSIONS
HORIZONTAL DIMENSIONS
WARNING
THIS FURNACE IS NOT APPROVED
OR RECOMMENDED FOR HORIZONTAL
APPLICATION OR INSTALLATION
ON ITS BACK, WITH ACCESS DOORS
FACING UPWARDS.
NOTES: ➀ May require a 3" [76 mm] to 4" [102 mm] or 3" [76 mm] to 5" [127 mm] adapter.
➁ May be 0" [0 mm] with type B vent.
➂ May be 1" [25 mm] with type B vent.
Furnaces must be vented in accordance with National Fuel Gas Code, ANSI 2223.1 and/or Can/CGA-B149 Installation Codes, and in
accordance with local codes.
[ ] Designates Metric Conversions
TABLE 1. DIMENSIONS AND CLEARANCE TO COMBUSTIBLE MATERIAL (INCHES) [mm]
ACCESSORY RETURN
AIR CABINETS
Return Air Cabinets may be installed
on either side application except
RXGR-C24B (side application must
be on side opposite gas and
electrical connections).
THE RXGR-C24B MUST ONLY BE INSTALLED
ON THE SIDE OPPOSITE THE GAS
& ELECTRICAL CONNECTIONS
Before proceeding with installation, refer
to installation instructions packaged
with each model, as well as complying
with all Federal, State, Provincial, and
Local codes, regulations, and practices.
“In keeping with its policy of continuous progress and product improvement, Manufacturer reserves the right to make changes without notice.”
PRINTED IN U.S.A. 11-09 DC FORM NO. X66-1255 REV 1
Supersedes Form No. X66-1255
MODEL
TONS A B C D E
RGPS-
3
05
3 & 4 171/2 [445] 1611/32 [415] 123/8 [314]➀151/2 [381] 0
3 171/2 [445] 1611/32 [415] 123/8 [314]➀151/2 [381] 0
41/2 & 5 211/2 [533] 1927/32 [504] 141/8 [359]➀181/2 [470] 0 0 0 1 [25] 3 [76]
5
5
141/2 [356] 1227/32 [326] 105/8 [270]➀111/2 [292]
07
10 EB
10EC &
10ED
12
241/2 [622] 2311/32 [593] 157/8 [403]➀221/2 [559]
2 [622]
15
241/
2311/
32 [593]
157/
8 [403]
➀
2 [559] 0
221/
F
17/8 [48]
21/2 [64]
21/2 [64]
21/2 [64]
21/2 [64]
2 [64]
21/
LEFT
SIDE
0
0
REDUCED CLEARANCE (IN.) [mm]
RIGHT
BACK TOP FRONT VENT
SIDE
4 [102] ➁
3 [76] ➁
3 [76] ➁
0 1 [25] 3 [76]
0 1 [25] 3 [76]
0 1 [25] 3 [76]
0 0 1 [25] 3 [76]
0 0 1 [25] 3 [76]
6 [152] ➂
6 [152] ➂
6 [152] ➂
6 [152] ➂
6 [152] ➂
6 [152] ➂
SHIP. WGTS.
(LBS.) [Kg]
85 [38.6]
105 [47.6]
115 [52.2]
120 [54.4]
140 [63.5]
150 [68] .
RETURN AIR CABINETS
A
RXGR-C14B 141/4 [356] (2) 12 x 16 [305 x 406]
RXGR-C17B 171/2 [445] (2) 12 x 16 [305 x 406]
RXGR-C21B 211/4 [533] (2) 20 x 16 [508 x 406]
RXGR-C24B 241/2 [622] (2) 24 x 16 [610 x 406]
IN. [mm]
FILTER SIZE
IN. [mm]
Loading...