Rheem RUUD Electric Commercial Water Heater, Ruud Eclipse ME85, Ruud Eclipse ME105 Specifications
Eclipse Electric Commercial Water Heaters
Available in 85 and 105 Gallon Capacities
12 KW through 24 KW
208, 240, 270 and 480 voltages
Rheem-Ruud Eclipse electric commercial water heaters are designed to
provide hot water where applications require moderate quantities. These
units are suited for a wide variety of applications such as retail stores, small
offices or any location where a moderate amount of hot water is required.
Construction Features:
• Composite tank and high density
polyethylene dent and scratch
resistant jacket.
• Models are in two sizes with
capacity of 85 or 105 gallons in
42 total variations.
• Input options are: 12.4, 18 or
24 kW.
• Voltage options are: 208, 240, or
480 VAC in either single phase or
3-phase and 277 VAC in single
phase only.
• Element wattages are 3100,
4500 or 6000 in each of the four
voltages. The elements are low
watt density design (46, 67, 90
watts/sq. in.) with stainless
(Inconel) sheath.
• The four Inconel elements are
spaced on the front along a
vertical line for easy access.
• The power control circuits use 2
surface mounted thermostats and
operate in two stages so that a
lower control thermostat is for the
lower two elements and an upper
control is for the upper two
elements. The lower element will
provide recovery for all needs and
the upper two will kick in additionally for larger demands.
• 170° F maximum delivered
temperature.
• System Sentinel LED indicators
are provided for each element to
show power on.
• A switch is provided in the control
circuit for installation dry fire
protection. See label.
• A temperature and pressure relief
valve is installed on top of the unit.
• Water connections at the top of
the tank are 1" swivel nuts. A
nipple is installed on the outlet
(1" x 3" long). The inlet has a
vacuum valve connected with
a 1 x 1 x 3/4 tee and a 1" close
nipple to the swivel.
• 3/4" full flow drain valve.
• Standards approved to UL 1453
and UL/NSF 005.
Certifications and Ratings:
• Efficiency – These models have been tested according to DOE test
procedures, and exceed the minimum energy factor requirements of
current ASHRAE Standards (Part of the Federally mandated Energy Policy
Act (EPact)). Also exceeds energy efficiency codes of all states including
California Energy Commission (CEC).
• Safety and Construction– These products are design certified by
Underwriters Laboratories (UL) to meet UL standard 1453 as electric
storage tank water heaters. All models are North Carolina and
Massachusetts Code compliant. Certified for a 150 PSI Maximum
Working Pressure.
Continued on reverse.
Exclusive 10 Year
Limited Tank Warranty
Lightweight –
less than half of
conventional products
No Anode Required
System Sentinel
™
Inconel Heating
Elements
Industry Leading
Insulation Factors –
means very low
operating costs
N
T
E
L
D
A
N
B
E
O
P
R
E
A
D
T
N
O
I
R
N
Y
A
•
•
T
®
E
S
Y
T
T
E
I
F
N
A
G
S
F
C
O
I
L
R
B
P
U
Water heater(s) shall be model _____________, manufactured by RHEEM-RUUD,
having electrical input of __________ kW and a recovery rate of _____________ GPH
at a 100°F temperature rise. Water heater(s) shall have a storage capacity of
__________ gallons. Water heater(s) shall have the UL seal of certification and be
factory equipped with an AGA/ASME rated temperature and pressure relief valve.
Water heater(s) shall meet or exceed the energy factor requirements of ASHRAE.
Tanks shall have a working pressure rating of 150 psi, and shall be completely
assembled. Tanks shall be insulated with 2-1/2" of rigid polyurethane foam insulation.
Water heater(s) shall be equipped with surface mounted thermostats. Water heater(s)
shall be covered by a ten year limited warranty against tank leaks.
Limited Warranty
This product features a ten year limited warranty against tank leaks. Please refer to
Commercial Warranty Information brochure for complete warranty information.
Recommended Specifications:
COMMERCIAL
WATER HEATERS
Rheem Water Heaters • 101 Bell Road, Montgomery, Alabama 36117-4305 • www.rheem.com
Rheem Canada Ltd./Ltée,128 Barton Street West, Hamilton, Ontario L8N 3P3
PRINTED IN U.S.A 11/06 WP FORM NO. RR102CE-6 Rev. 3
In keeping with its policy of continuous progress and product improvement, Rheem-Ruud reserves the right to make changes without notice.
Eclipse continued.
Recovery Capacities Recovery at various temperature rises
TEMPERATURE RISE
INPUT EQUIVALENT 40°F 50°F 60°F 70°F 80°F 90°F 100°F 110°F 120°F
KW BTU/HR UNITS (22°C) (28°C) (33°C) (39°C) (45°C) (50°C) (56°C) (61°C) (67°C)
12.4 42,309 GPH 126 100 84 72 63 55 50 45 42
LPH 478 379 318 273 239 209 190 171 159
18 61,420 GPH 186 149 124 106 93 83 74 68 62
LPH 705 565 470 402 352 315 280 258 235
24 81,893 GPH 248 199 165 142 124 110 99 90 83
LPH 940 754 625 538 470 417 375 341 315
FULL LOAD CURRENT – IN AMPERES
INPUT NUMBER ELEMENT NUMBER NUMBER
208V 240V 277V 480V
KW OF ELEMENTS WATTAGE OF FUSES OF THERMOSTATS PHASE 1 PHASE 3 PHASE 1 PHASE 3 PHASE 1 PHASE 1 PHASE 3
12.4 4 3100 8 2 60 39 52 34 45 26 17
18 4 4500 8 2 87 57 75 50 65 38 25
24 4 6000 8 2 115 76 100 66 87 50 35
MODEL APPROX. SHIP.
NUMBER UNITS
ABCD
WEIGHT
ME85 inches 28-1/4 66-1/4 70-1/4 4-1/2 170 lbs.
mm 718 1683 1784 114 77 kgs.
ME105 inches 30-1/4 66-1/2 70-3/4 4-1/2 185 lbs.
mm 768 1689 1797 114 84 kgs.
Electrical Characteristics
Dimensional Information All dimensions shown in English and Metric
D
B
C
A
Loading...