Rheem *HC-TST305UNMS Series, *HC-TST314UNMSSeries, *HC-TST412MDMS Series, *HC-TST422DFMS Series, *HC-TST501CMMS Series Quick Setup Manual

Quick Set-up Thermostat Guide

Touchscreen Programmable
Thermostats

*HC-TST305UNMS • *HC-TST314UNMS • *HC-TST412MDMS • *HC-TST422DFMS
*HC-TST501CMMS (programming section only)

for MODELS:

System/Remote Sensor Conguration ................................................................................................................................ 2

Dual Fuel Conguration ....................................................................................................................................................... 4

Dual Fuel using Software Logic ...................................................................................................................................... 4

Dual Fuel using Outdoor Remote Sensor ...................................................................................................................... 5

Programming Your Thermostat ............................................................................................................................................ 7

Set Current Time and Day ................................................................................................................................................... 9

Programming ....................................................................................................................................................................... 10

Operating ............................................................................................................................................................................. 11

Table of Contents

Quick Set-Up Guide for Touchscreen Thermostat 1

Installation Instructions for models:

 *HC-TST305UNMS

*HC-TST314UNMS

*HC-TST412MDMS

*HC-TST422DFMS

*HC-TST501CMMS(programming section only)

Quick Set-Up Guide for Touchscreen Thermostats

+HDW
3XPS
&RS\
6\VWHP2Q
&RRO6DYLQJV
(0+HDW0RGH
&DOO)RU6HUYLFH

'H+XP2Q

&KDQJH

$XWR

6FKHGXOH

+XPLGLW\

0RUQLQJ
'D\
(YHQLQJ
1LJKW
)LOWHU
3DG
89/DPS

0RQWK
<HDU

+XPLGLW\

2XWGRRU5HPRWH

+ROG8QWLO+XPLGLW\



NOTE:

These instructions are to be used for very basic installation only; they are intended to help the installer to

quickly set-up for basic operation and not set-up special features.

2 Quick Set-Up Guide for Touchscreen Thermostats

Quick Set-Up Guide for Touchscreen Thermostat 3

Installer, please perform the following steps.

1. Press the touch key.

2. Press and hold for 5 seconds the touch

key.

3. This displays Menu Reference number 1 from

the Installer Conguration Menu. The default
is MS2 (Multi-stage selection). Use the or

touch keys to select to make a selection

of system type.

4. Press once to continue to Menu

Reference number 2 (GAS or ELE).

5. The default is GAS (gas furnace selection.

Use the or touch keys to select ELE
(Electric furnace selection).

6. Press repeatedly to change to the

Remote sensor screen.

Menu Reference item no. 25 for:

*HC-TST314UNMS
*HC-TST412MDMS
*HC-TST422DFMS

Menu Reference item no. 27 for:

*HC-TST305UNMS

SYSTEM/REMOTE SENSOR CONFIGURATION

press repeatedly

or

default

default

Configuration Menu Reference no. 1

Configuration Menu Reference no. 2

or

or

or

or

Quick Set-Up Guide for Touchscreen Thermostat 3

7. The default is Remote OFF for (remote

sensor disabled). If no change is required,

then press

once to move to the next

Menu Reference number; otherwise, use the

or touch keys to select Remote On

(enables the remote sensor).

8. Press once to move to Menu sub-

selection for setting remote sensor location.
The default is Remote In (Indoor remote

sensor). Use

or touch keys if Outdoor

Remote (Outdoor remote sensor) is desired.

9. Press once. If Remote In sub-selection

will change to choose local sensor. Default
is Ls On – Local sensor enabled. Use

or

touch keys to change to LS OFF – Local

sensor disabled.

SYSTEM/REMOTE SENSOR CONFIGURATION

5HPRWH

2XWGRRU5HPRWH

Menu remote sensor has sub-selections
that will appear if installer selects the
Remote (On) setting.

Selecting this setting
will enable Dual Fuel
(dF) feature using
outdoor remote sensor
(see page 5)

Dual Fuel (dF) feature using
software logic (see next page)

5HPRWH

5HPRWH

or

or

or

default

default

default

NOTES

A. Menu selection will skip Dual Fuel setup if Menu Reference number 1 was not changed to HP1 or HP2. If HP1 or HP2 was selected, then Menu selection

for Dual Fuel using software logic or Dual Fuel using outdoor remote sensor will appear on the display depending on the remote sensor selection.

B. Press

touch key to exit the Installer Conguration Menu.