R for Rabbit CHERRY BERRY User Manual

Description of Parts

How to Assemble Cherry Berry – The Convertible High Chair

1. Assemble the Table

 Turn the table over and install all the four table legs one by one,

refer the figure above to install it correctly.

 Keep pushing the table leg inside the socket till you hear an

audible click. Make sure every snap hook on the steel tube is popping
out of the holes in the table base.

 Insert the foot cap of the table. Adjust the angle of the foot cap to

balance it well on the floor.

2. Assemble the Chair

 Insert the chair legs in the chair bottom.

 There are two chair legs marked with ‘A’, install them in the holes

marked ‘A’. Push the chair legs in the hole till you hear and audible

click. Check for the snap hook on the steel tube, it should pop out
from the holes overlapped by steel tube. Pull and check to ensure it is
installed correctly.

3. Install the chair top

Push down the chair top on the chair bottom till you hear an audible click.
Pull on the chair top to make sure it is installed securely.

Insert the safety belt in the holes given on the chair.

Connect the chair with the table to make a high chair:

Place the table assembly so that the side with R for Rabbit logo is facing towards the
front. Then insert the chair legs of the assembled chair in the holes provided on the
table.

Note: The chair bottom will not install into the table unless the front of the chair and table are aligned
correctly. So make sure the logo side of the table is facing front when assembling the high chair.

Assemble or disassemble Dinner Plate:

Insert the dinner plate at an angle of 30-45 degrees in the socket given in the chair bottom.

Make sure the spring clip at the bottom of the dinner plate goes into the right position while assembling.

WARNING: Do not leave the child unattended.

WARNING: Please use the safety belts correctly.

WARNING: Ensure the harness s correctly fitted and adjusted before use.

Please read the instructions carefully before use, and keep this manual for future reference.

 Make sure to assemble the high chair according to the instructions given in this manual, failure to do

so can be injurious to the child.

 Keep the package material away from babies. The materials can be hazardous to health and can cause

serious injury.

 Check all the parts before using. Fix or change the part/parts if damaged.
 Do not use corrosive chemicals to clean.
 Keep away from solarisation, fire, chemical, sharp objects or other dangerous environment.
 The high chair is suitable for kids from 6 months to 6 years old child.
 Do not allow the child to play, hang, climb in or out of the high chair.
 Use the high chair on flat and stable floor. Do not put overweight stuff on the chair tray, it may cause

the high chair to overturn.

R for Rabbit Baby Products Pvt Ltd

G- 508, Titanium City Center, Anand Nagar Road, Prahladnagar, Ahmedabad – 380015. Gujarat, India.

[phone] | [e-mail] | www.rforrabbit.com | www.facebook.com/TheRforRabbit