RF-Link APW-1000 User Manual
DC JACK
RF-Link
www.rflinkusa.com
3. Connect Power adapter(120VAC / 12VDC 500mA) to DC JACK
QUICK INSTALL GUIDE
Model: APW-1000
5.8GHz Outdoor RF Power Amplifier
1. PACKA GE CONTENTS：
Make sure that all units shown as below are enclosed,
please contact your dealer if anything is missing.
1
3. SETUP GUIDE
1. Connect transmitter antenna to APW-1000 (via "RF OUT).
2. Connect SMA cable to tranmitter (via "RF IN:).
+
4. SPECIFICATION :
RF Singnal from
RF Singnal from
Transmitter
Transmitter
Model: APW-1000
Model: APW-1000
RF IN
RF IN
RF OUT
RF OUT
DC IN
DC IN
RF Singnal
RF Singnal
to Antenna
to Antenna
1. -- APW-1000 Outdoor RF Amplifier *1
2. -- Waterproof Power Cable( 2 m) *1
3. -- Cable (SMA male, 25") *1
4. -- Power adapter (input: 120V DC, 60Hz, 9.7W output: 12V DC, 500mA) *1
2. FUNCTION
1 -- SMA FEMALE ;RF Signal Input
2 -- DC power input ,connect to power supply (12V~28V)
3 -- SMA FEMALE ;RF Signal Output
1
1
2
2
Model:APW-1000
Model:APW-1000
RF IN
RF IN
DC IN
DC IN
RF OUT
RF OUT
2
Operating frequency range 5.0---6.0 GHz
P1dB 26 dBm
Power gain 18 dB typical
Match impedance 50 Ohm
Input VSWR 2:1
Supply voltage +12 ~ +28 VDC
Supply current < 380 mA
Dimension 125 mm * 80 mm * 40 mm
Operating temperature -20 to +65 Ԩ
Storage temperature -40 to +85 Ԩ
Waterproof Rate IP 65
NOTE:
1. Keep the coaxial cable between the APW-1000 and Transmitter as short as possible.
3
3
2. Keep the coaxial cable between the APW-1000 and Antenna as short as possible.
3. Make certain all connections are tight.
4. Make certain all screws has locked on the cover.
Loading...