Revolution l Operating Instructions Manual

Robotic Pool Cleaner REVOL

by

UTION I

EN

Operating Instructions

Robotic Pool Cleaner REVOLUTION I ...................

p.

1-8

8151626

Robotic Pool Cleaner REVOLUTION I

Operating Instructions

Contents

1. INTRODUCTION .............................................................................2

2. SPECIFICATIONS ............................................................................2

3. WARNINGS AND CAUTIONS ........................................................2

3.1. Warnings ................................................................................2

3.2. Cautions .................................................................................2

4. POOL CLEANER PARTS ..................................................................3

5. USING THE POOL CLEANER .........................................................4

5.1. Setup ......................................................................................4

5.2. Putting the Pool Cleaner into the pool ...............................4

5.3. Removing the Pool Cleaner from the pool .........................5

5.4. Maintenance ..........................................................................6

5.4.1. Cleaning the filtration system.....................................6

5.4.2. Cleaning the impeller................

5.5. Off-season storage ...............................................................8

..................................7

Robotic Pool Cleaner REVOLUTION I | Operating Instructions

1

Robotic Pool Cleaner BASIC 2

Operating Instructions

1. INTRODUCTION

Thank you for purchasing a REVOLUTION Pool Cleaner.
We are sure that your REVOLUTION Robotic Pool Cleaner will provide you with reliable, convenient
and cost effective pool cleaning. Its reliable filtration in all pool conditions and all-surface climbing
brush enhance maximum pool hygiene.
The Robotic Pool Cleaner deliver advanced cleaning technologys, long lasting performance and
easy maintenance.

2. SPECIFICATIONS

Motor protection: IP 68
Minimum depth: 0.80m / 2.6ft
Maximum depth: 5m / 16.4ft

Power Supply

Digital “Switch-Mode” Power Supply

• Input-100-250ACVolts

• 50-60Hertz

• 180Watt

• Output-<30VDC

• IP54

3. WARNINGS AND CAUTIONS

3.1. Warnings

• Use the originally supplied power supply only

• Ensure the electrical outlet is protected by a ground fault interrupter (GFI) or an earth

leakage interrupter (ELI)

• Keep the power supply out of standing water

• Position the power supply at least 3m / 10ft away from the edge of the pool

• Do not enter the pool while the pool cleaner is working

• Unplug the power supply before servicing

3.2. Cautions

Use the Pool Cleaner in the following water conditions only:

Chlorine Max 4 ppm
pH 7.0 - 7.8
Temperature 6 – 34°C / 43-93°F
NaCl Maximum = 5000 ppm

2

Robotic Pool Cleaner REVOLUTION I | Operating Instructions

4. POOL CLEANER PARTS

Robotic Pool Cleaner BASIC 2

Brushes

PVC Brush

For concrete, PVC,
fiberglass and liner

Filtration

There are two filter level options, only one is provided with your robot cleaner. Cartridge with ultra-fine
filter included. Optional net filters for heavy debris.

Cartridge with ultra-fine filters included filters (x4), net filters optional

Power Supply Unit

Robotic Pool Cleaner REVOLUTION I | Operating Instructions

3

5. USING THE POOL CLEANER

5.1. Set Up

40°C Max

104°F Max

Position the power supply so
that it is approximately in the
middle of the long side
of the pool at a distance of
3m / 10ft.

Attach the floating cable to the
power supply by inserting it
with the notch on the
connector (1) lined up with
the groove in the socket on
the power supply and turning
clockwise (2).

GFI/ELI

A

2

1

5.2. Putting the Pool Cleaner into the pool

Shake the Pool Cleaner from side to side or
turn it upside down to release trapped air.

Let it sink to the pool floor.

4

Robotic Pool Cleaner REVOLUTION I | Operating Instructions

Turn the power supply ON.

5.3. Removing the Pool Cleaner from the pool

The Pool Cleaner will perform automatic shut-off at
the end of the cleaning cycle.

Turn OFF and unplug the power supply.

Using the floating cable, bring the
Pool Cleaner to the pool’s edge.

OFF

DO NOT PULL THE POOL CLEANER FROM THE POOL USING THE CABLE.

Robotic Pool Cleaner REVOLUTION I

| Operating Instructions

5

Click

5.4. Maintenance

5.4.1. Cleaning the filtration
system:

Cleaning the cartridge filters

Note: Don’t let the cartridge filters dry out before cleaning.

Unplug the power supply.

With the pool cleaner upside down
open the bottom lid and pull it out.

Open the clips and remove the filters.

Clean the filters with a hose.

Robotic Pool Cleaner REVOLUTION I | Operating Instructions

6

Insert the filters with the plastic backing
facing out.

Insert the cartridge unit.

5.4.2. Cleaning the impeller

Unplug the power supply.

If you notice debris trapped in the
impeller open the impeller and remove
the debris.

Place the impeller cover at an angle so that
the notch is on the second ring of the spring.

Press down on the impeller cover in the
direction of the spring, pushing it into place.

Replace the screws.

7

Robotic Pool Cleaner REVOLUTION I | Operating Instructions

Cable

To remove the
kinks, stretch
the cable out
completely and let
it sit for at least a
day in the sun.

5.5. Off-season storage

If the pool cleaner will not be in use for an extended
period, perform the following storage steps:

• Make sure that no water is left in the pool cleaner.

• Thoroughly clean the filter bag or cartridge and insert in

place.

• Roll up the cable so that it has no kinks.

• Store the pool cleaner upright in a protected area out of

direct sun/rain/frost at a temperature of between
5˚-45˚C / 41˚-113˚F.

Storage stand optional

Robotic Pool Cleaner REVOLUTION I | Operating Instructions

8

obotic Pool Cleaner REVOLUTION I

by

R

8151626