Revolabs XG-80 User Manual

Revolabs HD Single / Dual Channel System — Sony XG-80 Setup Guide

This setup guide will guide you through the steps needed to properly connect a
Revolabs HD Single or Dual Channel System to a Sony XG-80 video codec.

Note:

It is important to carefully follow these instructions in order and completely.
Otherwise your Revolabs Microphone System and/or the video codec may not function
properly. Please read through these instructions completely before proceeding.
Contact Revolabs technical support if you have any questions.

Requirements for connecting systems:

1. Revolabs HD Single or Dual Channel System

2. Sony XG-80 video codec

3. QTY 1 3.5mm unbalanced male to 3.5mm unbalanced male cable*

* 07-35MUTO35MU-01 3.5mm unbalanced male to 3.5mm unbalanced male

cable available from Revolabs

Connecting the Cables

1. Insert the unbalanced 3.5mm male connector to the CH 1 OUT port on the
Revolabs Single or Dual Channel System. If using a Single Channel, DIP Switch
#1 should be “OFF”. If using a Dual Channel, DIP Switch #1 should be “ON”.

2. Insert the other 3.5mm male connector into the “MIC (A1/A3) 1R” port on the
Sony XG-80.

3. Verify that DIP Switch #3 (mic/line) is “ON”

2

2

Configuring the Sony XG-80 Video Codec

1. Push the TOOLS button on the remote control

2. Select SETUP

3. Select AUDIO 1

4. Select AUDIO INPUT as MIC

5. Verify that Mic (A1/A3) has a checkmark

6. Turn ECHO CANCELLER to ON