Revolabs VSX 8000 User Manual

Revolabs HD Single / Dual Channel System — Polycom VSX 8000 Setup Guide

This setup guide will guide you through the steps needed to properly connect a
Revolabs HD Single or Dual Channel System to a Polycom VSX 8000 video codec.

Note:

It is important to carefully follow these instructions in order and completely.
Otherwise your Revolabs Microphone System and/or the video codec may not function
properly. Please read through these instructions completely before proceeding.
Contact Revolabs technical support if you have any questions.

Requirements for connecting systems:

1. Revolabs HD Single or Dual Channel System

2. Polycom VSX 8000 video codec

3. QTY 1 3.5mm balanced male connector to 3-pin mini Phoenix connector
cable*

* 07-35MBTOMPHX-01 6’ 3.5mm balanced male connector to 3-pin mini
Phoenix connector cable available from Revolabs

3.5MM STEREO MALE TO PHOENIX CONNECTOR CABLE DIAGRAM

Revolabs either recommends using the Revolabs 07-35MBTOMPHX-01 6’ 3.5mm balanced
male connector to 3-pin mini Phoenix connector cable, or cutting the end off an 1/8” cable and
attaching the green Phoenix connector as shown above.

Connecting the Cables

1. Insert the balanced 3.5mm male connector to the CH 1 OUT port on the Single
or Dual Channel System. If using a Single Channel, DIP Switch #1 should be
“OFF”. If using a Dual Channel, DIP Switch #1 should be “ON”.

2. Insert the green mini Phoenix connector into the red AUDIO INPUT AUX port.

3. Verify that DIP Switch #3 (mic/line) is “OFF”

2

2

Configuring the Polycom VSX 8000 Video Codec

1. Select SYSTEM

2. Select ADMIN SETTINGS

3. Select AUDIO

4. Set Red LINE INPUT to AUDIO MIXER

5. ENABLE Echo Canceller