Revolabs Single Channel System - Polycom VSX7000s Setup Guide
NOTES AND CA UTIONS:
This setup guide will guide you through the steps needed to properly connect a
Revolabs Single Channel System to a Polycom VSX7000s video codec.
1. Connecting the Cables
2. Configuring the VSX7000s Video Codec
Note:
It is important to carefully follow these instructions in order and completely.
Otherwise your Single Channel System and/or the video codec may not function
properly. Please read through these instructions completely before proceeding.
Contact Revolabs technical support if you have any questions.
Requirements for connecting systems:
1. Revolabs Single-Channel System
2. Revolabs 2.5mm to RCA Audio Cable (included with Single -Channel)
3. Polycom VSX7000s video codec
4. Qty 2 RCA-RCA male cable
5. Amplified speakers
Connecting the Cables
CONNECT ING A REVOLABS SINGLE CHANNEL SYSTEM TO POLYCOM VSX7000S VIDEO CODEC
1. Connect a Revolabs 2.5mm to RCA audio cable between the 2.5mm analog
output on the Single Channel System and the red “LINE INPUT ” port on the
VSX7000s.
Configuring the VSX7000s Video Codec
CONFIGURING THE A UDIO MENUS OF T HE VSX7000S VIDEO CODEC
1. Select SYSTEM
2. Select ADMIN SETTINGS
3. Select AUDIO
4. Set Red LINE INPUT to AUDIO MIXER
5. ENABLE Echo Canceller
6. DISABLE Polycom microphones by removing checkmark on ENABLE POLYCOM
MICROPHONES
Loading...