Revolabs HDX 9001, HDX 9002 User Manual

Revolabs Single Channel System - Polycom HDX 9001/9002 Setup Guide

NOTES AND CAUTIONS:

This setup guide will guide you through the steps needed to properly connect a
Revolabs Single Channel System to a Polycom HDX 9001/9002 video codec.

1. Connecting the Cables

2. Configuring the HDX 9001/9002 Video Codec

Note:

It is important to carefully follow these instructions in order and completely.
Otherwise your Single Channel System and/or the video codec may not function
properly. Please read through these instructions completely before proceeding.
Contact Revolabs technical support if you have any questions.

Requirements for connecting systems:

1. Revolabs Single-Channel System

2. Revolabs 2.5mm to RCA Audio Cable (included with Single -Channel)

3. Polycom HDX 9001/9002 video codec

4. Polycom Audio Adapter Cable (P/N 2457-23492-001) or equiva lent*

*POLYCOM HDX 9000 SERIES VIDEO CO DECS HAVE PHOENIX CONNECTORS FO R AUDIO INPUT/OUTPUT WHILE REVOLABS
FUSION PRO DUCTS USE RCA CONNECTORS FOR AUDIO INPUT/OUTPUT. THE POLYC OM AUDIO ADAPTER CABLE CONVERTS

TWO PHO ENIX CONNECTO RS INTO FEMALE RCA CO NNECTORS. OTHERWISE, A TECHNICIAN COULD SIMPLY CUT OFF THE
ENDS OF THE RCA CA BLES AND CONNECT PER THE DIAGRAM ON THE FOLLOWING PAGE: