Revolabs HDX 7000 User Manual

Revolabs Fusion™ Microphone System - Polycom HDX 7000 Setup Guide

NOTES AND CAUTIONS:

This setup guide will guide you through the steps needed to properly connect a
Revolabs Fusion Microphone System to a Polycom HDX 7000 video codec.

1. Connecting the Cables

2. Configuring the HDX 7000 Video Codec

Note:

It is important to carefully follow these instructions in order and completely .
Otherwise your Fusion M icrophone System and/or the video codec may not function
properly. Please read through these instructions completely before proceeding.
Contact Revolabs technical support if you have any questions.

Requirements for connecting systems:

1. Revolabs Fusion 4 or 8 Channel Microphone System

2. Polycom HDX 7000 video codec

3. Qty 2 RCA-RCA male cable

4. Amplified speakers

Connecting the Cables

CONNECT ING A REVOLA BS FUSIO N MICROPHONE SYSTEM TO POLYCOM HDX 7000 VIDEO CODEC

1. Connect a Male RCA-RCA audio cable between the “CONF OUT” port on the

Fusion and the red “Audio Input AUX” port on the HDX 7000.

2. Connect a Male RCA-RCA audio cable between the “CONF IN” port on the Fusion

and the red “AUDIO OUTPUT 1” port on the HDX 7000.

3. Connect a Male RCA audio cable between the “Room Out” port on the Fusion and

the Speakers.

Note: The speakers used for audio and video conferencing with this
configuration must be connected to the Fusion for proper echo cancellation.