Revolabs Executive HD Microphone System — Tandberg C60/C90 Setup
This setup guide will guide you through the steps needed to properly connect a
Revolabs Executive HD Microphone System to a Tandberg C60 or C90 video codec.
Note:
It is important to carefully follow these instructions in order and completely.
Otherwise your Executive HD Microphone System and/or the video codec may not
function properly. Please read through these instructions completely before
proceeding. Contact Revolabs technical support if you have any questions.
Requirements for connecting systems:
1. Revolabs Executive HD 4 or 8 channel Microphone System
2. Tandberg C60 or C90 video codec
3. XLR male to mini-Phoenix cables
NOTE: The Tandberg C60 has 4 microphone inputs and the C90 has 8
microphone inputs. Therefore, the 4-channel Executive HD will interface
directly only to the C60 while both the 4 and 8 channel Executive HD
systems will interface directly with the C90.
NOTE:
THE TANDBERG CODEC C90 ADMINISTRATOR’S GUIDE © JULY 2009
IMAGES OF SET UP SCREENS ARE DEFAULT SETTINGS FROM TANDBERG AND ARE PART OF
Connecting the Cables
1. Connect the first mini Phoenix – XLR audio cable between the Executive HD
OUT 1 port and the “MIC 1” port on the Tandberg C60/C90.
2. Continue connecting mini Phoenix to XLR cables between the Executive HD and
Tandberg codec as needed (8-channel Executive HD and C90 codec shown)
1
1
Configuring the Tandberg C60/C90 Video Codec
1. Select SETTINGS
2. Select ADVANCED
3. Select ADVANCED CONFIGURATION
Configuring the Tandberg C60/C90 Video Codec
4. Select AUDIO
5. Select INPUT
6. Select MICROPHONE 1
7. Select ECHO CONTROL and turn ON
8. Select NOISE REDUCTION and turn ON
9. Do this for all applicable microphone inputs
Loading...