Revolabs 75, 95 MXP, 85 User Manual

Revolabs Fusion™ Wireless Microphone System- Tandberg Edge 75/85/95
MXP Setup Guide

NOTES AND CAUTIONS:

This setup guide will guide you through the steps needed to properly connect a
Revolabs Fusion System to a Tandberg Edge 75/85/95 MXP video codec.

1. Connecting the Cables

2. Configuring the Edge MXP Video Codec

Note:

It is important to carefully follow these instructions in order and completely.
Otherwise your Fusion System and/or the video codec may not function properly.
Please read through these instructions completely before proceeding. Contact Revolabs
technical support if you have any questions.

Requirements for connecting systems:

1. Revolabs Fusion 4 or 8 microphone system

2. Tandberg Edge 75/85/95 MXP video codec

3. QTY 1 XLR male to XLR male cable

4. Qty 2 RCA-RCA male cable

5. Amplified speakers

NOTE: IMAGES OF SET UP SCREENS ARE DEFAULT SETTINGS FROM TANDBERG AND ARE PART OF THE
TANDBERG MXP ADMINISTRATOR’S GUIDE © MAY 2008

Connecting the Cables

CONNECTING A REVOLABS FUSION TO TANDBERG EDGE 75/85/95 MXP VIDEO CODEC

1. Connect a Male RCA-RCA audio cable between the “Conf. In” port on the Fusion
and the “VCR 1” port on the Edge MXP.

2. Connect a Male XLR audio cable between the “Mic Conf. Out” port on the Fusion
and the “Mic 1” port on the Edge MXP.

3. Connect a Male RCA audio cable between the “Room Out” port on the Fusion and
the Speakers.

Note: The speakers used for audio and video conferencing
with this configuration must be connected to the Fusion for
proper echo cancelation.