Revolabs 9004 User Manual

Revolabs Single Channel System - Polycom HDX 9004 Setup Guide

NOTES AND CAUTIONS:

This setup guide will guide you through the steps needed to properly connect a
Revolabs Single Channel System to a Polycom HDX 9004 video codec.

1. Connecting the Cables

2. Configuring the HDX 9004 Video Codec

Note:

It is important to carefully follow these instructions in order and completely.
Otherwise your Single Channel System and/or the video codec may not function
properly. Please read through these instructions completely before proceeding.
Contact Revolabs technical support if you have any questions.

Requirements for connecting systems:

1. Revolabs Single Channel System

2. Revolabs 2.5mm to RCA Audio Cable (included with Single Channel)

3. Polycom HDX 9004 video codec

4. Polycom Audio Adapter Cable (P/N 2457-23492-001) or equiva lent*

*POLYCOM HDX 9000 SERIES VIDEO CO DECS HAVE PHOENIX CONNECTORS FO R AUDIO INPUT/OUTPUT WHILE REVOLABS
SINGLE CHANNEL SYSTEM PRODUCTS USE RCA CO NNECTORS FOR AUDIO INPUT/OUTPUT. THE POLYCOM AUDIO ADAPTER

CABLE CONVERTS TWO P HOENIX CONNECTORS INTO FEMALE RCA CONNECTORS. OTHERWISE, A TECHNICIAN COULD SIMPLY
CUT OFF THE ENDS OF THE RCA CABLES AND CONNECT PER THE DIAGRAM ON THE FOLLOWING PAGE: