Revolabs 6000, 8000 MXP User Manual

Revolabs Fusion™ Wireless Microphone System- Tandberg 6000 / 8000 MXP
Setup Guide

NOTES AND CAUTIONS:

This setup guide will guide you through the steps needed to properly connect a Revolabs
Fusion System to a Tandberg 6000 / 8000 MXP video codec.

1. Connecting the Cables

2. Configuring the 6000 / 8000 MXP Video Codec

Note:

It is important to carefully follow these instructions in order and completely.
Otherwise your Fusion System and/or the video codec may not function properly. Please
read through these instructions completely before proceeding. Contact Revolabs technical
support if you have any questions.

Requirements for connecting systems:

1. Revolabs Fusion 4 or 8 microphone system

2. Tandberg 6000 / 8000 MXP video codec

3. QTY 1 XLR male to XLR male cable

4. Qty 2 RCA-RCA male cable

5. Amplified speakers

NOTE: IMAGES OF SET UP SCREENS ARE DEFAULT SETTINGS FROM TANDBERG AND ARE PART OF THE
TANDBERG MXP ADMINISTRATOR’S GUIDE © MAY 2008

Connecting the Cables

CONNECTING A REVOLABS FUSION TO TANDBERG 6000 / 8000 MXP VIDEO CODEC

1. Connect a Male RCA-RCA audio cable between the “Conf. In” port on the Fusion
and the “VCR 1” port on the 6000 / 8000 MXP.

2. Connect a Male XLR audio cable between the “Mic Conf. Out” port on the Fusion
and the “Mic 1” port on the 6000 / 8000 MXP.

3. Connect a Male RCA audio cable between the “Room Out” port on the Fusion and
the Speakers.

Note: The speakers used for audio and video conferencing with
this configuration must be connected to the Fusion for proper
echo cancelation.