Revolabs 8000, Tandberg 6000 User Manual

Revolabs Single Channel Wireless Microphone System- Tandberg 6000 / 8000
MXP Setup Guide

NOTES AND CAUTIONS:

This setup guide will guide you through the steps needed to properly connect a Revolabs
Single Channel System to a Tandberg 6000 / 8000 MXP video codec.

1. Connecting the Cables

2. Configuring the 6000 / 8000 MXP Video Codec

Note:

It is important to carefully follow these instructions in order and completely.
Otherwise your Single Channel System and/or the video codec may not function properly.
Please read through these instructions completely before proceeding. Contact Revolabs
technical support if you have any questions.

Requirements for connecting systems:

1. Revolabs Single Channel System

2. Tandberg 6000 / 8000 MXP video codec

3. QTY 1 07-STEMIC-PPP Line-to-Mic Interface Cable*

* OPTIONAL FROM REVOLABS

NOTE: IMAGES OF SET UP SCREENS ARE DEFAULT SETTINGS FROM TANDBERG AND ARE PART OF THE
TANDBERG MXP ADMINISTRATOR’S GUIDE © MAY 2008

Connecting the Cables

CONNECTING A REVOLABS SINGLE CHANNEL TO TANDBERG 6000 / 8000 MXP VIDEO CODEC

1. Connect the 07-STEMIC-PPP cable between the 2.5mm analog output of the
Revolabs Single Channel to the MIC 1 input of the Tandberg 6000 / 8000 MXP