Revolabs 0HDEXEMIC User Manual

Revolabs HD™ Single/Dual

Wireless Microphone System

Models: 02-HDSGL, 02-HDDUAL, 04-HDSGLEU, 04-HDDUALEU,

04-HDSGLCN, 04-HDDUALCN

User and Set-up Guide

© 2010-2014 REVOLABS, INC. All rights reserved. No part of this document may be
reproduced in any form or by any means without express written permission from Revolabs,
Inc. Product specifications are subject to change without notice.

R e v o l a b s H D ™ S i n g l e & D u a l M a n u a l

01-HDSGLMAN-PAP-11

April 2014 (Rev 2.9)

Contents

Safety and General Information .................................................................................................................... 4

Introduction.................................................................................................................................................... 8

System Components ................................................................................................................................ 8

Installing the Revolabs HD ™ Base Station .................................................................................................. 9

Controls and Connections: ....................................................................................................................... 9

Configuring the Revolabs HDTM Base Station ............................................................................................. 10

Using the Rear Panel Configuration DIP Switches ................................................................................ 11

Using the Revolabs HD Control Panel Software .................................................................................... 12

Revolabs HD Microphones and HD Microphone Adapters ......................................................................... 15

Using the HD Wearable Wireless Microphones ..................................................................................... 15

Using the HD Omni-Directional Tabletop Wireless Boundary Microphones .......................................... 16

Using the HD Directional Tabletop Wireless Boundary Microphones .................................................... 18

Using the HD XLR Microphone Wireless Adapter .................................................................................. 19

Using the HD Wireless Adapter for Countryman Microphone ................................................................ 20

Pairing Wireless Microphones to Base Station....................................................................................... 21

Revolabs HDTM Single or Dual Charger Base............................................................................................. 22

Power Module ......................................................................................................................................... 22

Charging the Microphone Batteries ........................................................................................................ 22

Updating the Revolabs HDTM Firmware ...................................................................................................... 23

Revolabs HD™ Indicator LEDs ................................................................................................................... 24

Warranty ...................................................................................................................................................... 25

Specifications .............................................................................................................................................. 26

Index ............................................................................................................................................................ 27

Safety and General Information

Please read the following information to ensure safe and efficient use of your Revolabs system.
FCC User Information
FCC ID: T5V02HDDUALNM Revolabs HD™ Dual Base Station
FCC ID: T5V0HDEXEMIC Revolabs Executive HD ™ Microphone

FCC Notice to Users

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)
this device may not cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.

Users are not permitted to make changes or modify the equipment in any way. Changes or modifications not
expressly approved by Revolabs, Inc. could void your authority to operate this equipment under Federal
Communications Commission’s rules.

. RADIO AND TELEVISION INTERFERENCE
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to

Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference by
one or more of the following measures:

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment and the receiver.

- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

- Consult the dealer or an experienced radio/TV technician for help.

You may also find helpful the following booklet, prepared by the FCC: "How to Identify and Resolve Radio-TV
Interference Problems." This booklet is available from the U.S. Government Printing Office, Washington D.C.

20402.

- 4 -

Industry Canada Notice to Users

This Class B digital apparatus complies with Canadian ICES-003.
Operation is subject to the following two conditions:
(1) This device may not cause interference and
(2) This device must accept any interference, including interference that may cause undesired operation of the

device
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de

licence. L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil ne doit pas produire de
brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le
brouillage est susceptible d'en compromettre le fonctionnement.

IC 6455A-01HDEXEC Revolabs HD™ Dual Base Station
IC: 6455A-0HDEXEMIC Revolabs Executive HD ™ Microphone

RF Exposure:

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. The
antenna(s) used for this equipment must be installed to provide a separation distance of at least eight inches
(20 cm) from all persons. This equipment must not be operated in conjunction with any other antenna.

This device complies with RF exposure requirements in Industry Canada RSS-102 Issue 4.

For Body Worn Operation:

SAR data information for residents in countries that have adopted the SAR limit recommended by the
International Commission of Non-Ionizing Radiation Protection (ICNIRP), which is 0.08 W/kg averaged over
the whole body or 2.00 W/kg averaged over ten (10) gram of tissue (for example European Union, Japan,
Brazil and New Zealand): The highest SAR value for this product when tested for use on the body is 0.35 W/kg
(averaged over 10g).

Professional Installation Recommended

This product should be professionally installed.

Notice to Customers in Australia

 Do not use the areas where there are explosive hazards
 Do not use in environments where there is a danger of ignition of flammable gasses.

Restricted use with certain medical devices
Hearing Aids

Some devices may interfere with some hearing aids. In the event of such interference, you may want to consult
with your hearing aid manufacturer to discuss alternatives.

Other Medical Devices

If you use any other personal medical device, consult the manufacturer of your device to determine if it is
adequately shielded from RF energy. Your physician may be able to assist you in obtaining this information.

- 5 -

Export Law Assurances

04-HDSGLEU-NM

HD Single Channel System, 1-Channel, w/o mics

04-HDDUALEU-NM

HD Dual Channel System 2-Channel, w/o mics

03-HDEXEMICEU-11

HD Microphone, Wearable

03-HDTBLMICEU-OM-11

HD Microphone, Tabletop, Omni-directional

03-HDTBLMICEU-DR-11

HD Microphone, Tabletop, Directional

03-HDXLRMICEU-11

HD, XLR Wireless Adapter for Dynamic Handheld Microphone

03-HDCOMANEU-11

HD Wireless Adapter for Countryman Microphone

This product is controlled under the export regulations of the United States of America and Canada. The
Governments of the United States of America and Canada may restrict the exportation or re-exportation of this
product to certain destinations. For further information contact the U.S. Department of Commerce or the
Canadian Department of Foreign Affairs and International Trade. The use of wireless devices and their
accessories may be prohibited or restricted in certain areas. Always obey the laws and regulations on the use
of these products.

02-HDSGL and 02-HDDUAL (1 & 2 channel systems respectively) North America
UPCS Usage Restriction

Due to the UPCS frequencies used, this product is licensed for operation only in the United States of America
and Canada.

04-HDSGLEU and 04-HDDUALEU (1 & 2 channel systems respectively) European
Union Usage Restriction

Due to the DECT frequencies used, this product is licensed for operation only in the European Union countries
including Australia.

Notice to European Customers

190, High Street,
Tonbridge, Kent,

TN9 1BE,

UK.

Declare that for the hereinafter mentioned product model numbers, the presumption of conformity with the

applicable essential requirements has been approved in accordance with Council Directive 1999/5/EC “Radio

and Telecommunications Terminal Equipment” and RoHS II Directive 2011/65/EU.

Any unauthorized modification of the products voids this Declaration.
For a copy of the original signed declaration of conformity, please contact Revolabs at the above address.

- 6 -

WEEE Notification:

The Waste Electrical and Electronic Equipment (WEEE) directive (2012/19/EU) is intended to promote
recycling of electrical and electronic equipment and their components at end of life.

According to the requirement of the WEEE legislation the following user information is provided to customers
for all branded Revolabs products subject to the WEEE directive.

“The symbol on the product or its packaging indicates that this product must not be disposed of with your
other household waste. Instead, it is your responsibility to dispose of your waste equipment by handing it over
to a designated collection point for the recycling of waste electrical and electronic equipment. The separate
collection and recycling of your waste equipment at the time of disposal will help conserve natural resources
and ensure that it is recycled in a manner that protects human health and the environment. For more
information about where you can drop off your waste for recycling, please contact your local authority, or
where you purchased your product.”

- 7 -

Introduction

Congratulations on your purchase of a Revolabs Digital Wireless Microphone System! This system
utilizes 1.9 GHz DECT technology, and high band-width audio from multiple wireless microphones,
enabling clear, reliable, un-tethered communications in recording, audio/video conferencing, speech
recognition, VOIP communications, sound re-enforcement as well as many other environments
requiring clear audio capture.

The Revolabs HD™ Single and Dual Channel Wireless Microphone Systems have high definition
audio, 50 Hz to 14 kHz, which allows the systems to pick up the entire human voice spectrum. The HD
Single and Dual Channel Systems are a unique marriage of innovative technology and ergonomic
design, employing Multi-Carrier Time Division Multiple Access and Time Division Duplex
(MC/TDMA/TDD) radio transmissions both to and from the microphone.

This technology allows the microphones to co-exist with other wireless products such as wireless LANs
(802.11b&g), and includes digital encryption technology to ensure secure communications.

System Components

Depending on which system you’ve purchased, your Revolabs HD™ System contains the following:

 Mountable Single or Dual Channel Base Station
 Single or Dual Channel Microphone Charger Base
 HD Wireless Microphones, purchased and boxed separately

The Base Station houses the processor and one end of the wireless connection. It features one set of
PCB diversity antennae and offers individual line-level or mic-level audio in/out for each microphone
channel.

This allows for external audio processing such as:
 Mixing

- 8 -

 Acoustic echo cancellation (AEC)

1

2

3 4 5 6 7

 Feedback elimination
 Level control
 Equalization
 Noise cancellation

The system is designed to optimize audio capture/reproduction by providing:

 Consistent audio input from all participants
 Minimum room noise
 Mute control
 Wireless encryption
 Automatic channel selection
 Full duplex audio

The Charger Base charges the HD Wireless Microphones and stores them when not in use.

Installing the Revolabs HD ™ Base Station

The Revolabs HD ™ Channel Base Station, shown below in front and rear panel views, manages
wireless audio signal processing, pairing, and muting between the Revolabs microphones and the Base
Station.

Front View

Rear View

Controls and Connections:

1. Channel LED indicators: Displays microphone mute and pairing states

2. Pairing Push Buttons: For pairing microphones to Base Station

3. Power In Receptacle (100-240 VAC)

4. 3.5mm Balanced Input Connectors

5. 3.5mm Balanced Output Connectors

6. Mini-USB Serial Interface

7. Configuration DIP Switches (see Section Using the Rear Panel Configuration DIP switches)

- 9 -