REVELL Concerta IW65, RIB 6W Install Manual

Revel® RIB 6W Rough-In Bracket

Installation

Thank you for purchasing the Rough-In Bracket for your Revel® 6-1/2” In-Wall Loudspeaker. Follow
the instructions below to install the rough-in bracket. Please note that the bracket installation must
be done before the wall board is put up.

Step 1: Snap the two flat
wing sections onto the frame
as shown.

Use the wing edge with
the two larger holes.

WIRE TABS

Step 2: Position the Rough-In Bracket/Wing assembly
between the wall studs so that the bracket is in the correct
position for the final speaker placement. Nail the assembly
into place, making sure that the nail heads are as flush
against the wings as possible.

Note:
Make sure that the wire tabs on the assembly are in the
back, so they are on the inside of the wall.

WIRE

Step 3: Use the wire tabs to hold pre-routed speaker wires in

TABS

place. Ensure that no wire remains exposed on the front (wall
board) side of the assembly.

Step 4: After the wall board is installed, cut out the hole for the speaker using the inside cut-out of the
frame as a guide. The speaker wire can then be run through the opening in the wall board and attached to
the speaker system - refer to the Owner’s Manual of the loudspeaker for more information on system
setup.

Harman Specialty Group
3 Oak Park Drive
Bedford, MA 01730-1413
USA

Revel Part No. 170-0095 | Rev 0 | 02/07

Tel [phone]
Fax [phone]

www.revelspeakers.com

Customer Service
Tel [phone]
Fax [phone] (Sales)
Fax [phone] (Service)