![](/html/d2/d232/d232f3f85a72d2aef814626898a6f7620ec48a9030eb83ad707cfddfeeae16e0/bg1.png)
WWW.REVELL.COM
BASIC RACER SETBASIC RACER SETBASIC RACER SET
INSTRUCTIONS
Read the entire instruction sheet before beginning assembly. Adult supervision is required!
WARNING:
CHOKING HAZARD — Small parts.
Not for children under 3 years of age.
Shape the Body
1
1. Draw a design
on the top and
sides.
2. Clamp block in a
vise. Cut out shape
with coping saw.
Detail the Body
2
1. Remove all dust.
Apply a thin coat
of paint. When dry
scu lightly with
ne sandpaper.
Repeat as needed.
Do not scu the
nal coat.
2. Apply either dry
transfer or peel and
stick decals.
3. Smooth shape
with rasp. Start
with the coarse
section, then the
ne.
4. Sand the body.
Using coarse
sandpaper rst.
Followed with
medium grit paper
and ne grits.
Install the Wheels and Axles
3
3. Apply an even
layer of clear coat
with a foam brush.
Apply more layers
as needed.
1. Place a wheel
on all four axles.
Press them into the
axle slots.
![](/html/d2/d232/d232f3f85a72d2aef814626898a6f7620ec48a9030eb83ad707cfddfeeae16e0/bg2.png)
P
AGE 2
PAGE 2
WWW.REVELL.COM
2. Slide an wheel
adjustment tool
between the wheel
and body. Move
the wheel until the
tool ts snugly.
3. Put car on
a smooth, at
surface. Put
camber check
section of tool
against each
wheel. Adjust
each axle until the
wheel is parallel to
the tool.
4. Apply graphite
powder between
the axle head and
wheel. “Work in”
the powder by
shaking the car
and slowly turning
the wheel.
5. Apply graphite
powder between
the body and
wheels.
More great Revell products!
1. Carving Set (RMXY9648)
2. Paint & Brush Set (RMXY9630)
3. Dry Transfer Decals (RMXY9619- 9625) and Peel & Stick Decals (RMXY9627- 9629)
4. O cial Wheel and Axle Sets (RMXY9608- 9612)
5. O cial Pinewood Derby® Wheel Adjustment Tool™ (RMXY9616)
6. Graphite Powder (RMXY9614)
REVELL® INC. 1850 HOWARD ST., UNIT A, ELK GROVE VILLAGE, IL 60007 U.S.A.
MADE IN CHINA • ENTIRE CONTENTS © COPYRIGHT 2009
RMXY9632