Resolution REHP1AZ0 User Manual

Quick Install Guide

REHP1AZ0 Panel Replacement Module

Before you start, ensure the following equipment is included in the package:

• Panel Replacement Module (PRM)

• Battery

• Power Supply

• Hardware Kit: (3) #8 screws, (3) wall anchors, and (2) #4 cover screws

Quick Setup

TEST AND REMOVE LEGACY SYSTEM

1

A Test and label existing/legacy set-up

B Power down and remove legacy battery

C Remove legacy system to make room for the PRM

MOUNT THE PRM

2

WIRE ZONES & SIRENS

3

A Wire non-powered sensors

B Wire powered sensors

C When wiring 2-Wire smoke detectors, connect to zone 1 only

D When wiring 4-Wire smoke detectors, connect to zones 2-8
E If using a siren, connect to siren power terminals

CONNECT THE BATTERY AND POWER SUPPLY, THEN POWER UP THE PRM

4

PAIR THE PRM AND ZONES TO THE TOUCHSCREEN

5

TEST AND COMPLETE THE INSTALLATION

6

A Test and verify proper operation of the system

B Close the cover and secure the cover with screws

TRADEMARKS

ZIGBEE IS A REGISTERED TRADEMARK OWNED BY THE ZIGBEE ALLIANCE. HONEYWELL AND
SYSTEM SENSOR ARE REGISTERED TRADEMARKS OWNED BY HONEYWELL INTERNATIONAL
INC.

FCC NOTICE

THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION IS SUBJECT TO THE
FOLLOWING TWO CONDITIONS:

1) THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE.

2) THIS DEVICE MUST ACCEPT ANY INTERFERENCE THAT MAY BE RECEIVED, INCLUDING
INTERFERENCE THAT MAY CAUSE UNDESIRED OPERATION.

CHANGES OR MODIFICATIONS NOT EXPRESSLY APPROVED BY RESOLUTION PRODUCTS, INC.
COULD VOID THE USER’S AUTHORITY TO OPERATE THIS EQUIPMENT.