Resolution RE926 User Manual
RE926S Wifi Module
Features
•
Connects in the daughter board slot of a GE SimonXT security panel.
•
Allows reporting of alarm status conditions over Wifi connection to a home internet
network.
•
Allows control of system functions (arming, disarming, etc.) over Wifi connection.
•
Allows control of additional wireless sirens in alarm conditions.
•
Easy Wifi connection to existing secured network using WPS functionality.
Key Instructions
•
Power down the SimonXT panel, and open the back cover.
•
Install the RE926S unit into the slot at the back of the panel.
•
Power up the panel.
•
Press the button labeled WPS on the RE926S until the red Wifi LED starts flashing.
•
Press the WPS button on the Wifi router or access point.
•
Wait until the security information is exchanged and a stable connection is made, this may
take one to two minutes to complete.
•
Close the back cover on the panel.
•
Connect to configuration software and enter MAC address.
•
Configure RE926S to correct IP address for reporting.
•
Configure RE926S to correct IP address for system control.
LED Operation
•
The Wifi LED should be lit red when connected to Wifi network, and may flicker when
sending and receiving network data.
•
Power LED lights green when powered and shows a 'heartbeat' for processor functioning
correctly.
•
CS LED lights when connected to Central Station
•
Platform LED lights when connected to interactive platform website.
RE926S Wifi Module User Manual Page 1 of 5
www.resolutionproducts.com
Specifications
Panel Compatibility: GE/Interlogix SimonXT
Power Supply: 9-18V DC, minimum 100mA.
Current draw: 70-85mA, normal operation
PCB dimensions: 1.9 x 4.1 inches
Specifications subject to change without notice.
Internal Pictures
Top view:
Factory Default Switch
Daughter board connector
External Siren Connector
Side view:
Status LEDs
Wifi Module
WPS Button
RE926S Wifi Module User Manual Page 2 of 5
www.resolutionproducts.com
Loading...