Resolution RE636 User Manual

RE636 Wireless Outdoor Siren Strobe

I

Connect+™ Encrypted

The RE636 Wireless Outdoor Siren Strobe is an auditory

warning device that produces high volume warning sounds and
visual strobing.

Features

• Multi-cadence siren

• 100 dBA minimum at 1m

• 2-5 year battery life (batteries included) or AC powered
(RE012-17 sold separately)

• 5-year warranty

Sounds a high volume warning for burglary, smoke and carbon

monoxide alarm conditions. Volume is adjustable through the
Connect+ Installer application, or through the interactive service
provider’s web portal.

Enroll by placing the panel and siren into wireless enrollment

mode. The siren’s PWR and RF LEDs will blink back and forth
when in enrollment mode. If the siren has never been enrolled,
enrollment mode will start automatically when opening the
cover. To overwrite a previously enrolled ID, power up the
device while holding the tamper. When the red RF LED
illuminates, release the tamper switch. After enrolling the siren,
take the panel out of wireless enrollment mode.

• Once the siren is properly enrolled, test functionality in a
desired location.

• The panel supports up to eight RE636 sirens at one time.

Mounting Holes

A

T

S

L

L

N

I

G

E

U

D

I

Replace batteries by opening the cover and removing the inner

cover to gain access to the 3 C-cell batteries.

• To remove inner cover, push down the two latches, then

pull out the clear inner cover.

Mounting can be done by securing the siren to a surface with the

mounting screws (included) at the three slotted mounting holes.
Ensure arrows inside are pointed up.

Pro Tips

• Cover can hang from bottom of enclosure and inner cover can
clip into cover for convenience while work is being done inside
enclosure.

• To change the strobe lens, unscrew the cover screw until it
is past the lens, and then push on the corner of the lens to
loosen and remove. Select desired color.

• Power (PWR) LED will turn on when the siren is awake (every
18 seconds on battery and always when powered from wall).

• RF LED will blink when a packet is received.

• Enroll packets are automatically sent every 18 seconds when
in enroll mode. Pressing or releasing the tamper switch while
sensor is in enroll mode will send another enroll packet.

Use the panel installation guide to verify proper system setup.

Inner cover
removal
latches

Specications

Physical

Housing Dimensions
Weight with Batteries
Mounting Hardware

Environmental

Operating Temperature
Maximum Humidity

Sensor Specications

Frequency
Replacement Battery
Battery Life
Battery Voltage
Current Draw
Sounder Loudness
Wall Connection (Optional)
Transmitted Indications

Certication

RE636 FCC, IC

Specications subject to change without notice

12.0 x 11.2 x 2.2 inches (30.5 x 28.4 x 5.6 centimeters)

2.6 pounds (41.6 ounces)
3 Stainless Steel Mounting Screws

0°F to 130°F (-18°C to 55°C)
85% non-condensing relative humidity

433 MHz
3 Energizer® C-Cell Batteries
2-5 years, non rechargeable

4.5 VDC (nominal)
4uA (Sleep), 16mA (AC Power), 1.05A (Alarm)
100 dBA, minimum at 1m
US 2-prong electrical outlet blades (RE012-17)
Low Battery, Supervisions, Cover Tamper, Wall Tamper

AC/NZS 60950-1:2015
ETSI EN 300 220-2 V2.4.1 / AS/NZS 4268:2012
ETSI EN 301 489-1 V1.9.2
ETSI EN 301 489-3 V1.6.1

WARRANTY

Alula will replace all non-portable products that are defective in

their rst ve (5) years, and all portable products that are defective
in their rst two (2) years.

IC NOTICE

This device complies with Industry Canada license-exempt RSS
standard(s). Operation is subject to the following two conditions:

(1) This device may not cause interference, and
(2) This device must accept any interference, including interference

that may cause undesired operation of the device.

Le présent appareil est conforme aux cnr d’Industrie Canada
applicables aux appareils radio exempts de licence. L’exploitation
est autorisée aux deux conditions suivantes:

(1) L’appareil ne doit pas produire de brouillage, et
(2) L’utilisateur de l’appareil doit accepter tout brouillage

radioélectrique subi, même si le brouillage est susceptible d’en
compromettre le fonctionnement.

IC: 8310A-RE636

47-0063-00 • REV A • 2019-05-30

Tech Support Line • (888) 88-ALULA • [phone]

alula.net

FCC NOTICE

This device complies with Part 15 of the FCC rules. Operation is
subject to the following two conditions:

(1) This device may not cause harmful interference.
(2) This device must accept any interference that may be received,

including interference that may cause undesired operation.

Changes or modications not expressly approved by Alula could void

the user’s authority to operate this equipment.

FCC ID: U5X-RE636

TRADEMARKS

Alula and Connect+ are trademarks owned by Alula Holdings, LLC.

Energizer is a registered trademark owned by Energizer Brands, LLC.

02