Resolution RE304 User Manual

Batteries secured

Magnetic

Push battery down

transmission

Do not pull

Jumper on Low Sensitivity

Jumper on Medium Sensitivity

Jumper on High Sensitivity

Wireless
Security
Solutions

RE304 DSC®-Compatible Driveway Sensor

Features

• For sensing Vehicles passing by.

• Sensor continuously monitors earth’s magnetic field. When the large

metal mass of a vehicle drives by, the earth’s magnetic field is twisted.
The sensor then transmits a signal wirelessly to the control panel.

• Immune to pets, wildlife, leaves, dust, sunlight.

• NO DIGGING!

• Weatherproof design handles all environments.

• Strong, reliable RF signal.

• 3-5 year battery life on C battery.

• Low Battery indication.

Key Instructions

• Battery “+” face away from springs. Secure batteries with binder.

• Use as a chime function. Do not use as an alarm zone.

• Use 90-degree post mount bracket, or ground stake.

• Mount sensor within 12 feet of target vehicle. Mount more than 24 feet

from street.

• Do not plug drain & air holes. Do not overtighten top.

• Bumping the sensor will cause it to false (it thinks the world moved).

• Performance Effects:

Increased Response Decreased Response

Close to vehicle Far from vehicle
Higher (door handle level) Ground level
Slow vehicle Fast vehicle
Large metal vehicle Small vehicle with lots of plastic
Jumper on Hi Sensitivity Jumper on Lo Sensitivity

Generally, it shouldn’t matter which direction the sensor
head is rotated. But turning it 90 degrees may cause some
performance change +/-.

• Enrolling:

 Put panel in Wireless Enrollment Mode.
 Disconnect and then connect sensor battery. Special transmission

occurs on power-up, so that sensor enrolls.

 Confirm ESN, Enter Zone # and Zone Type on DSC Panel
 May also be enrolled via entering ESN.
 Use in “Chime” Group, not an Alarm Group.
 Supervision by panel is optional.

Page 1 of 3 www.ResolutionProducts.com 7/28/2011

RE304_DSC-Compat_Driveway_Instructions.doc

Specifications

Exploded Picture

antenna

towards spring,
and release to
cause enrollment

by binder

Page 2 of 3 www.ResolutionProducts.com 7/28/2011

Vehicle sense distance: 0 – 15 feet
Mounting hardware: post flange or ground stake
Replacement Battery: C-Cell
Temperature Range: 0F to 120F
[Note: high temperatures and high humidity can have a
significant effect on alkaline battery performance.]
Housing dimensions: 5.1 x 3.8 inches

Specifications subject to change without notice.

RE304_DSC-Compat_Driveway_Instructions.doc

sensor

Notices

“GE”, “Honeywell”, “DSC” and “Napco” are trademarks owned by General Electric Company,
Honeywell International Inc., Tyco Safety Products Canada LTD, and NAPCO Security Systems,
Inc., respectively.

Resolution Products, Inc. products will function with one of either GE, Honeywell, DSC or
Napco systems. However, no Resolution product is produced by, endorsed by, nor is officially
associated with GE, Honeywell, DSC or Napco. Resolution recommends verifying proper
enrollment and operation, per control panel installation instructions, at installation.

Warranty
Resolution Products, Inc. will replace products that are defective in their first year.

FCC Notice

This device complies with Part 15 of the FCC rules. Operation is subject to the
following two conditions:

This device may not cause harmful interference.
This device must accept any interference that may be received, including
interference that may cause undesired operation.

Changes or modifications not expressly approved by the Resolution Products, Inc. could
void the user's authority to operate this equipment.

FCC ID: U5X-RE304

IC Notice

This device complies with Industry Canada license-exempt RSS standard(s). Operation is
subject to the following two conditions:

1. This device may not cause interference, and

2. This device must accept any interference, including interference that may
cause undesired operation of the device.

Cet appareil est conforme avec d’Industrie Canada RSS standard exempts de licence.
Son fonctionnement est soumis aux deux conditions suivantes:

1. Ce dispositif ne peut causer des interférences, et

2. Ce dispositif doit accepter toute interférence, y compris les interférences
qui peuvent causer un mauvais fonctionnement du dispositif.

IC: 8310A-RE304

Page 3 of 3 www.ResolutionProducts.com 7/28/2011

RE304_DSC-Compat_Driveway_Instructions.doc