Resolution RE300 5 User Manual

I

RE300-5 DSC Compatible Keyfob

Keyfob is a portable device used to remotely control a

security system.

Features

• Supports for up to 8 button functions

• Low battery indication

• 5 year warranty

A

T

S

L

L

N

I

G

E

U

D

I

Enroll by placing the panel into wireless enrollment mode

and pressing a keyfob button multiple times as instructed
by the panel installation manual. Alternately, sensor ID
located on the back of the fob can be used to manually
enroll the sensor.

Assign User

• For most security panels, keyfobs
must be assigned to a user to function
properly.

To replace the battery, remove the screw on the back of

the keyfob and unsnap the back from the cover.

• After battery replacement, it may take
up to 3 button presses before the low
battery indication clears.

Pro Tips

Optional advanced button commands are sent by

pressing the lights button and another button at
the same time. Advanced button commands are
transmitted on a secondary ID which is the sensor’s
primary ID with the last digit replaced by a 1.

Unlock

Lights

Away

Star

Stay

LED

Secondary ID Commands

• Lights + Star = Star on secondary ID

• Lights + Unlock= Unlock on secondary ID

• Lights + Away = Arm away on secondary ID

• Lights + Stay = Arm stay on secondary ID

Screw

Verify proper enrollment and operation using your control panel’s installation manual.

Specications

Physical

Housing Dimensions
Weight with Battery

Environmental

Operating Temperature
Maximum Humidity

Sensor Specications

Frequency
Replacement Battery
Nominal Battery Life
Transmitted Indications

Certication

RE300-5 FCC, IC

2.2 x 1.5 x .6 inches (5.6 x 3.8 x 1.4 centimeters)
.66 ounces (19 grams)

32°F to 120 °F (0 to 49 °C)
85% non-condensing relative humidity

433.92 MHz
One Panasonic CR2032
4 to 6 years
Low Battery

Specications subject to change without notice

WARRANTY

Resolution Products, Inc. will replace products that are defective in

their rst ve (5) years.

IC NOTICE

This device complies with Industry Canada license-exempt RSS
standard(s). Operation is subject to the following two conditions:

(1) This device may not cause interference, and
(2) This device must accept any interference, including interference

that may cause undesired operation of the device.

Le présent appareil est conforme aux cnr d’Industrie Canada
applicables aux appareils radio exempts de licence. L’exploitation
est autorisée aux deux conditions suivantes:

(1) L’appareil ne doit pas produire de brouillage, et
(2) L’utilisateur de l’appareil doit accepter tout brouillage

radioélectrique subi, même si le brouillage est susceptible d’en
compromettre le fonctionnement.

IC: 8310A-RE3005

47-0016-03 • RevA • 2016-12-12

Tech Support Line [phone]

www.ResolutionProducts.com

FCC NOTICE

This device complies with Part 15 of the FCC rules. Operation is
subject to the following two conditions:

(1) This device may not cause harmful interference.
(2) This device must accept any interference that may be received,

including interference that may cause undesired operation.

Changes or modications not expressly approved by the

Resolution Products, Inc. could void the user’s authority to operate
this equipment.

FCC ID: U5X-RE300-5

TRADEMARKS

DSC is a trademark owned by TYCO Safety Products Canada LTD.

Resolution Products Inc. products will function with DSC systems.
However, no Resolution product is produced by, endorsed by, nor

is ofcially associated with TYCO. Resolution recommends verifying

proper enrollment and operation, per control panel installation
instructions, at installation.