Resolution RE220 LS User Manual

RE220-LS Wireless Security Sensor and Zwave Repeater

Features:

• Listens to other Lifeshield wireless devices and senosrs, and re-transmits them to the

main control panel.

• Extends range of system.

• No enrollment required to start repeating sensor signals.

• Received ID's are passed on unchanged to the security panel. All sensor alarms,

supervisory, and trouble signals are passed through.

• Repeater has its own unique ID for supervisories, complete reporting of main device
tamper, external power supply fault and low battery if desired.

• Dual antennas for both Receive and Transmit diversity for increased range.

• Back-up battery protects during loss of external power.

• After simple inclusion into an existing Zwave network, will act as active listening

repeater Zwave device on the network filling in range gaps between other distant
devices.

Key Instructions:

• Attached external supply.

• Install internal battery backup.

• Enroll sensors into panel as normal, the repeater should be transparent to other

devices.

• Optionally enroll repeater into security panel:
◦ Put security panel into enrollment mode, then press the red reset button on the

repeater. This will put the repeater into enrollment mode to report back
supervisories, battery information and tamper conditions.

• To repeat zwave signals, repeater must be enrolled into local network.
◦ Put zwave into enrollment mode on the security panel, then press the red reset

button on the repeater. This will also put the zwave repeater into enrollment
mode to be included onto the local network.

LED Operation:

• Blue LED indicates power

• Green LED flashes to indicate a security sensor signal was received

• Red LED flashed to indicate that signals are being sent out (repeated)

Specifications:

Lifeshield Wireless Sensor www.lifeshield.com Page 1 of 3
and Zwave Repeater User Manual

• External power supply: 5VDC. If using different supply, 100mA minimum required.

• Battery backup: 2600mAh Li-ion 3.7V 18650 rechargeable battery

• Dimensions and weight: 9 x 5 x 1.375”, 13.2oz

• Internal antennas

• Zwave chip: Zensys ZM5202

Speaker

LED Window

Grill for

Alarm sounds

Reset, and

Enrollment

Button

Lifeshield Wireless Sensor www.lifeshield.com Page 2 of 3
and Zwave Repeater User Manual

External

Power supply

Connector