Resolution RE118 User Manual

RE118 Interlogix® Compatible Trident™ Environmental Sensor

I

Trident is an integrated environmental sensor. It detects water

and reports extreme temperature conditions.

Features

• Titanium probes for unmatched corrosion immunity

• IP67 rated waterproof enclosure

• GORE® vent equalizes enclosure pressure

• 5 year warranty

Enroll by placing the panel into wireless enrollment mode and

then sending an enrollment signal from the sensor. The ood

signal is enrolled by default. To Enroll the freeze and heat
zones, remove the sensor cover. Use a wire or a paper clip
to short the desired outer terminal to the center terminal,
shorting one terminal at a time.

DL ID Conguration

• Flood zone is the serial number shown on the device

• Freeze zone is the serial number with last digit

replaced with a 1

• Heat zone is the serial number with last digit replace
with a 2.

A

T

S

L

L

N

I

G

E

U

D

I

Wall Clip

Install by placing the sensor in the location requiring water or air

temperature detection. If desired, the wall clip can be used to
secure the Trident sensor.

Optional Wall Clip Securing

Optional Wall Clip Securing

• Remove the Trident body from wall clip.

• Remove the Trident body from wall clip.

• Secure wall clip to a surface with a #6 mounting

• Secure wall clip to a wall with a #6 screw.
screw.

• Example securing locations are a wall, baseboard

• Example securing locations: wall, baseboard or

or cupboard.

Mounting Screw Hole

Detects water pooled under the sensor and reports extreme air

temperature conditions.

Default Temperature Trip Points

• Heat alarms when over 100.4° F (38° C)

• Heat restores when under 96.8° F (36° C)

• Freeze alarms when under 44.6° F (7° C)

• Freeze restores when over 48.2° F (9° C)

To replace the battery, insert a at blade screwdriver into the

front slot and twist. To reinstall the cover, align the rear latches
and roll the cover forward until it snaps into place.

Front slot

Verify proper enrollment and operation using your control panel’s installation manual.

Specications

Physical

Housing Dimensions
Weight with Battery
Mounting Fastener

Environmental

2.43 x 2.48 x 1.17 inches (6.2 x 6.3 x 3 cm)

1.34 ounces (38 grams)
#6 screw (not provided)

Operating Temperature
Maximum Humidity
Water Resistance

32 to 120 °F (0 to 49 °C)
85% non-condensing relative humidity
IP67 rated (waterproof for over 30 minutes at 1 meter depth)

Sensor Specications

Frequency
Replacement Battery
Nominal Battery Life
Battery Voltage
Current Draw
Transmitted Indications

319.5 MHz
Two Panasonic CR2032
10 years

3.0 VDC (Nominal) 2.3 VDC (Low)
20 mA (Maximum) 0.5 uA (Quiescent)

Cover Tamper, Wall Tamper, Low Battery, Supervision

Certication

RE118 FCC, IC

Specications subject to change without notice.

WARRANTY

Resolution Products, Inc. will replace products that are defective in

their rst ve (5) years.

IC NOTICE

This device complies with Industry Canada license-exempt RSS
standard(s). Operation is subject to the following two conditions:

(1) This device may not cause interference, and
(2) This device must accept any interference, including interference

that may cause undesired operation of the device.

Le présent appareil est conforme aux cnr d’Industrie Canada
applicables aux appareils radio exempts de licence. L’exploitation
est autorisée aux deux conditions suivantes:

(1) L’appareil ne doit pas produire de brouillage, et
(2) L’utilisateur de l’appareil doit accepter tout brouillage

radioélectrique subi, même si le brouillage est susceptible d’en
compromettre le fonctionnement.

IC: 8310A-RE118

FCC NOTICE

This device complies with Part 15 of the FCC rules. Operation is
subject to the following two conditions:

(1) This device may not cause harmful interference.
(2) This device must accept any interference that may be received,

including interference that may cause undesired operation.

Changes or modications not expressly approved by the Resolution

Products, Inc. could void the user’s authority to operate this
equipment.

FCC ID: U5X-RE118

TRADEMARKS

“Interlogix” is a trademark owned by United Technologies Electronic
Controls Inc.

Resolution Products, Inc. products will function with Interlogix
systems. However, no Resolution product is produced by, endorsed

by, or is ofcially associated with Interlogix.

Resolution recommends verifying proper enrollment and operation,
per control panel installation instructions, at installation.

47-0028-01 • RevA • 2016-11-10

Tech Support Line [phone]

www.ResolutionProducts.com